1) inclusion particle
夹杂物颗粒
1.
The flow fluid of tundish in the practical process is computed by mathematical modeling,on the ground of which the moving trajectory of inclusion particles using Gill method is traced,then the limit flow out size of inclusion is gained,and the optimun condition beneficial to inclusion removal is analyzed.
用数学模型的方法计算了中间包具体工艺条件下钢液的流场，在此基础上采用 Ｇｉｌｌ 法计算跟踪了夹杂物的运动轨迹，得到夹杂物颗粒上浮去除的极限尺寸，分析了中间包去除夹杂物的优化条
2) foreign particle
外来夹杂物颗粒
1.
Effect of foreign particles on the dendritic growth in phase-field theory;
外来夹杂物颗粒对枝晶生长形态影响的相场法研究
3) granularity of inclusions
夹杂物粒度
1.
Estimation of the maximum granularity of inclusions in steel with the statistic extreme method;
本文介绍了采用极值统计方法推测钢中最大夹杂物尺寸,其原理是确定子样个数,测出子样夹杂物最大粒度(子样夹杂物最大粒度呈极值分布,其最大值则服从特定的Gumbel分布函数),根据计算出的累积概率密度、标准量和子样的最大夹杂粒度,推测试样最大夹杂物粒度值。
4) Inclusion Size
夹杂物粒径
1.
Distribution of Inclusion Size in Surface Layer of IF Steel Slab under Unsteady Casting;
非稳态浇铸时IF钢铸坯表层夹杂物粒径的分布
5) inclusion particles
夹杂物粒子
1.
The numerical simulation study on flow field and inclusion particles removal was carried out with the water model of mold.
利用数值模拟方法研究了连铸结晶器水模型内吹气作用下的流动和夹杂物粒子去除效果,分析了吹气量对结晶器内流动和夹杂物粒子去除的影响规律。
6) particle entrainment
颗粒夹带
1.
To promote the understanding of these complex behaviors and the development of centrifugal fluidized bed (CFB), the paper investigated the bed expansion and particle entrainment, and analyzed the thermodynamic process in CFB dryer.
研究离心力流化床床层膨胀、颗粒夹带等动力学问题,分析床层中颗粒的热力干燥过程,对于离心流化床气固动力学模型和离心流化床设备的应用设计具有重要意义。
补充资料：GCr15钢中的大型非金属夹杂物(铝酸盐)×500
GCr15钢中的大型非金属夹杂物(铝酸盐)×500
GCrl5钢中的大型非金属夹杂物(铝酸盐) ×500
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条