1) helical baffles heat exchanger
螺旋隔板换热器
2) spiral-plate heat exchanger
螺旋板换热器
1.
Selection and design of LLI spiral-plate heat exchangers by computer simulation;
用计算机仿真方法解决LLI螺旋板换热器选型设计问题
2.
Application of the electrostatic water treatment on spiral-plate heat exchangers in the blast-cooling department;
静电水处理器在鼓冷工段螺旋板换热器中的应用分析
3.
This article introduces some structural features of spiral-plate heat exchanger and also summarizes the experience of successful application of it into unit operation in the industry of fine chemicals.
介绍了螺旋板换热器的结构特点,总结了螺旋板换热器在精细化工企业几个单元操作工序中成功应用的经验,提出了螺旋板换热器的使用要领及结构设计方面的改进意见。
3) spiral plate heat exchanger
螺旋板换热器
1.
In the production of potassium nitrate by using the method of decomposing ammonia nitrate and potassium chloride in cycle, based on the characteristics of the solution, spiral plate heat exchanger was applied to the process of cooling and crystallizing potassium nitrate solution.
在硝酸铵与氯化钾复分解循环法生产硝酸钾工艺中,根据溶液物料特性,设计并采用螺旋板换热器应用于硝酸钾溶液的冷却结晶工艺,生产硝酸钾,具有不结垢,传热系数高,能耗低,生产能力大,体积小,操作方便等优点。
2.
The difference of heat transfer calculation between spiral plate heat exchanger and single shell and tube heat exchange is discussed in the article.
本文讨论了在传热计算中螺旋板换热器与单壳程、单管程列管式换热器的差异。
3.
Based on the two type of the initial round of the spiral plate in the spiral plate heat exchangers, two methods for spiral calculation were presented in this article.
本文根据螺旋板换热器螺旋板初始圈的两种形状，提出了两类螺旋计算方法，与目前流行的方法比较，新方法更具系统性和准确性。
4) spiral plate heat exchanger
螺旋板式换热器
1.
Researches on the Heat Transfer Characteristics of the Spiral Plate Heat Exchangers with Non-Circular Pin Fins
椭圆形定距柱螺旋板式换热器的传热特性研究
2.
Application of spiral plate heat exchanger in visbreaker and FCC unit
螺旋板式换热器在减黏裂化和FCC装置上的应用
3.
The difference of heat transfer calculation between spiral plate heat exchanger and single shell and tube (type1 1) heat exchange is discussed herein.
讨论了螺旋板式换热器在传热计算中同单壳程单管程（１－１型）换热器在概念上的不同点。
5) spiral heat exchanger
螺旋板式换热器
1.
A self-made stainless steel spiral heat exchanger (50 m2) had been applied in the preheating procedure for matured mash for three years.
自制了1台50m2的不锈钢螺旋板式换热器作为蒸馏工艺的发酵成熟醪二次预热器,经3年的生产实践检验,该设备能使粗塔进醪温度达到75～95℃,提高蒸馏生产能力15%～20%。
2.
For the spin of inner part in the reactor during producing, it was considered that the spin occurred mostly by reason of the moment of force on the side of the spiral heat exchanger and the change of angular momentum caused by the change of fluid's flow in the spiral passage, according to the analysis of angular momentum and effect of force on the inne.
本文针对合成塔内件的旋转问题,通过对合成塔内件的受力情况以及系统角动量变化的分析,认为其内件的旋转主要是该内件底部的螺旋板式换热器侧面流体推力及通道内流体流量变化引起的流体角动量变化造成的。
6) helical plate heat exchanger
螺旋板壳式换热器
补充资料：螺旋板式换热器
分子式：
分子量：
CAS号：
性质：用两片金属板卷成螺旋形而构成换热壁的板式换热器。热流体和冷流体分别在金属板两边的沟槽内流动。中心室以隔板将沟槽隔开。优点是：（1）热量损失小；（2）设备紧凑；（3）单位传热面积大；（4）换热效率高。缺点是：（1）制造比较复杂；（2）设备必须注意密封；（3）操作压力通常不能超过表压0.5兆帕（5大气压）。
分子量：
CAS号：
性质：用两片金属板卷成螺旋形而构成换热壁的板式换热器。热流体和冷流体分别在金属板两边的沟槽内流动。中心室以隔板将沟槽隔开。优点是：（1）热量损失小；（2）设备紧凑；（3）单位传热面积大；（4）换热效率高。缺点是：（1）制造比较复杂；（2）设备必须注意密封；（3）操作压力通常不能超过表压0.5兆帕（5大气压）。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条