说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 还原焙烧-氨浸出
1)  reducing roasting ammoniacal leaching
还原焙烧-氨浸出
2)  Reduction roasting-ammonia leaching
还原焙烧-氨浸
3)  Roasting and leaching
焙烧浸出
4)  reduction roasting
还原焙烧
1.
Reduced iron powder was obtained by converting copperas to ferrous carbonate with(NH_4)_2CO_3,followed by reduction roasting with anthracite as reducer and CaCO_3 as additive.
提出了一种新的绿矾综合利用的途径,即绿矾经碳酸盐转化,然后采用无烟煤作还原剂,CaCO3为添加剂,进行高温还原焙烧制取还原铁粉。
2.
Zinc calcine contains a small amount of refractory zinc ferrite that can be reduced by reduction roasting.
锌焙砂含有少量难溶的铁酸锌 ,通过还原焙烧可以降低铁酸锌含量。
3.
The experiment of reduction roasting of strontium sulphate ore is carried out on a fluidized bed with the cross sectionof 0.
3m,处理量为60~70kg/h的流化床装置上进行了还原焙烧硫酸锶矿(天青石)的试验研究,获得焙烧操作的最佳工艺条件,锶矿还原率达75%~78%,吨产晶焙烧煤耗1。
5)  roasting reduction
还原焙烧
1.
By analyzing and researching utilization of BF dust,a technology of dealing with the BF gas slime adopting the containing carbon pellet direct roasting reduction method was put forward.
通过对攀钢高炉粉尘利用的分析研究,提出了采用含碳球团直接还原焙烧法处理高炉瓦斯泥的工艺。
2.
The optimal pa-rameters of roasting reduction in reduction atmosphere with a metallization rate up to more than 80% were determined by orthogonal method.
在还原气氛下进行了红土贫铁矿的还原焙烧实验,采用正交实验设计方法,以C/O、焙烧时间和焙烧温度为因素,在还原气氛下得到了最佳工艺条件为:C/O是0。
3.
The feasibility of roasting reduction method to dezinc the Zn bearing BF dust was proved by energy spectrum analysis and differential thermal(DT) and thermo gravimetric(TG) analysis firstly.
通过能谱、差热及热重分析等验证了用还原焙烧的方法脱除高炉含锌粉尘中锌的可行性。
6)  Reductive roasting
还原焙烧
1.
Investigation of extracting iron from pyrite cinder by reductive roasting;
用还原焙烧法从硫铁矿烧渣中提取铁的研究
2.
Reductive roasting is .
采用还原焙烧工艺对内蒙黄岗高锡铁精矿的处理进行了研究,考察了主要工艺参数对脱锡效果的影响。
3.
The reductive roasting of carbon-containing laterite by heating in microwave field has been studied.
研究了含碳红土矿在微波场中的加热还原焙烧,考察了不同含碳量情况下微波加热焙烧过程中的样品温度和产物的物相组成,以及浮氏体、磁铁矿和赤铁矿等不同价态的铁氧化物在微波场中的加热性能。
补充资料:氨浸出


氨浸出
ammonia leaching

o「、J Inehu氨浸出(ammonia leaehing)J下J含氨的水溶液作为浸出剂的浸出方法。氨是·种配位体,能与某些金属离子形成配合物(络合物)进入溶液。浸出过程一般通入氧作为氧化剂,氧化被浸出固体物料中的有价组分。氨浸出可在常压或加压下进行。含自然铜、氧化铜或碳酸铜的矿石,可在常压下浸出;而含铜、镍、钻、锌等硫化物精矿,则采用加压氧氨浸出,浸出温度通常为358一373K,氧气压力为0.7一1.4MPa。浸出液经蒸馏除去的氨,可用水吸收后循环使用。氨浸出的优点是能处理含铁高和含碱性脉石的矿物原料,设备的防腐问题容易解决。由于氨具有挥发性,氨浸出需要在密闭反应器内进行。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条