说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 离心萃取法
1)  entrifugal extraction
离心萃取法
1.
A new technique-centrifugal extraction, used for grease recovery,was intro-duced.
本文介绍了一个回收羊毛脂的新方法——离心萃取法
2)  Centrifugal extraction
离心萃取
3)  centrifugal extractor
离心萃取器
1.
Rare-earth extraction with the cylindrical centrifugal extractor;
圆筒式离心萃取器稀土萃取的试验研究
2.
By centrifugal extractor,under the condations of 1 L/h of flow volume,2/1 of phase rate,4000 r/min of centrifugal speed,5.
利用离心萃取器,在流量1 L/h,相比(Vo/Va)=2/1,离心转速4000 r/min,水相料液pH=5。
3.
The structure,working process and performance of centrifugal extractor are described and its applications in non-ferrous metallurgy are reviewed,such as separations of In and Fe,Ni and Co,Zr and Hf,and rare earths,extraction of Ge from zinc sulphate solution,and treatment of poor gold-bearing liquor from gold metallurgy.
介绍离心萃取器的结构、工作过程和性能,综述其在有色冶金中的应用,如铟铁分离、镍钴分离、锆铪分离、稀土元素分离、从硫酸锌溶液中提取锗、氰化浸金贫液处理,所有这些应用都获得满意结果。
4)  centrifugal contactor
离心萃取器
1.
Study on treating p-nitrophenol wastewater with HL-centrifugal contactor;
用HL离心萃取器处理含对硝基酚废水的研究
2.
The hold up volumes of aqueous phase and organic phase in an annular centrifugal contactor were measured by the liquid fast discharging method,and the interface radii were calculated from the hold up volumes using a suitable model of phase distribution.
系统研究了转速、流比、重相堰直径、流量、两相密度差和粘度6个参数对环隙式离心萃取器界面半径的影响。
3.
The process also included Co recovery, Pb removal by ion exchange, Research work is colnposed of extraction experim-nt ,bench-scale test and pilot test carried out in centrifugal contactors.
本流程进行了萃取平衡试验,并用离心萃取器进行了台架试验和半工业试验,结果表明,本流程是切实可行的。
5)  centrifugal extractor
离心萃取机
1.
The structure and the principle of the centrifugal extractor are described in this paper,the technical specifications of the centrifugal extractor made in China and foreign countries are compared introduced.
介绍了离心萃取机的结构和工作原理,国内外发展历程,对比了国内外机型的技术参数。
6)  Extraction-separation
萃取分离法
补充资料:离心机速率区带离心法

速率区带离心法是在离心前于离心管内先装入密度梯度介质(如蔗糖、甘油、KBr、CsCl等),待分离的样品铺在梯度液的顶部、离心管底部或梯度层中间,同梯度液一起离心。离心后在近旋转轴处(X1)的介质密度最小,离旋转轴最远处(X2)介质的密度最大,但最大介质密度必须小于样品中粒子的最小密度,即ρP>ρm。这种方法是根据分离的粒子在梯度液中沉降速度的不同,使具有不同沉降速度的粒子处于不同的密度梯度层内分成一系列区带,达到彼此分离的目的。梯度液在离心过程中以及离心完毕后,取样时起着支持介质和稳定剂的作用,避免因机械振动而引起已分层的粒子再混合。


  由于ρP>ρm可知S>0,因此该离心法的离心时间要严格控制,既有足够的时间使各种粒子在介质梯度中形成区带,又要控制在任一粒子达到沉淀前。如果离心时间过长,所有的样品可全部到达离心管底部;离心时间不足,样品还没有分离。由于此法是一种不完全的沉降,沉降受物质本身大小的影响较大,一般是应用在物质大小相异而密度相同的情况。常用的梯度液有Ficoll、Percoll及蔗糖。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条