1) shock treatment
电击处理
1.
Methods: Twenty-four female Wistar rats that had past the pretest,were randomly assigned to blank control,CPP model and shock treatment groups.
方法:24只通过CPP筛选的Wistar大鼠(♀),随机分为3组,分别为空白对照组、CPP模型组和电击处理组;CPP模型组和电击处理组采用倾向性训练程序训练大鼠(6d),每天的上午和下午分别进行吗啡匹配训练和生理盐水训练;空白对照组用生理盐水代替吗啡,其它处理和CPP模型组及电击处理组完全相同。
2) electropercussive processor
电冲击处理器
3) hammer peening
锤击处理
1.
Fatigue crack initiation and propagation characteristics for 16Mnq steel welding-joint at varied gap length by hammer peening are studied.
试验研究了 1 6Mnq钢焊接接头试件在不同缺口长度下 ,经锤击处理前后 ,缺口处疲劳裂纹的萌生寿命及扩展寿命的变化 ,分析测试了焊接接头在锤击处理后的残余应力分布 。
2.
Hammer peening is a kind of very effective process relieving welding residual stress, which has many unique advantages, and was applied widely in engineering.
锤击处理是一种非常有效的消除焊接残余应力的方法,具有独特的优越性,在实际工程中应用比较广泛。
4) heat shock
热击处理
1.
The cucumber seeds were treated with heat shock under the water temperature from 25 to 65℃ for 10～40 minutes.
用25~65℃恒温水浴对黄瓜种子进行热击处理10~40 min,结果表明,25℃处理30 min到55℃处理30 min,随着温度升高种子萌发率增大。
2.
This essay discusscs the influencc of heat shock to the germination of Oryza satiual.
本文研究了热击处理对水稻种子萌发和活力的影响。
5) shot peening
珠击处理
6) ionic bombardment
轰击处理
1.
Chromium and nickel ions were introduced into a conventional ion-nitriding furnace to realize a simultaneous multi-ionic bombardment on the surface of austenitic stainless steel AISI316.
采用金相、扫描电镜、电化学工作站等分析手段研究了在普通离子氮化炉引入铬、镍离子源,对奥氏体不锈钢进行铬、镍、氮多元离子淹没轰击处理后材料的表面形貌、成分和耐蚀性能等。
补充资料：神抶电击
1.谓如神电之笞击。喻进击疾速。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条