1) push-out test
剪切黏结实验
1.
Evaluation of factors affecting retention of two fiber posts using push-out test;
两种纤维桩固位影响因素的剪切黏结实验研究
2) shear test
剪切实验
1.
The results show that shear strength parameters from a shear test and a triaxial compressive test are not consistent, and that friction angle changes with a regularity of continuous decreasing from the shear of intact rock to the triaxial compression of rock mass to the shear of structural planes.
对红层软岩的大量实验表明,剪切与三轴压缩实验测得的抗剪强度参数值不一致,而且内摩擦角从完整岩石剪切实验、三轴压缩实验到结构面剪切实验呈现出由大到小的规律。
3) shearing-bonding strength
黏结剪切强度
1.
Effects of nano-diamond filler on shearing-bonding strength and micro-hardness of pit and fissure sealant;
纳米金刚石填料对光固化窝沟封闭剂黏结剪切强度和表面显微硬度的影响
4) shear fatigue of bonding layerz
黏结层剪切疲劳
5) shear bond strengths
剪切黏结强度
6) shear viscosity
剪切黏度
1.
The proposed model indicates that the yield stress is one of the main causes for the shear-thinning effect and reveals why some materials possess double-Newtonian regions with the shear viscosity in the first region higher than that in the second region.
它揭示了某些材料存在的双牛顿区现象,并证明第一牛顿区的剪切黏度大于第二牛顿区的。
2.
A number of inventive methods have been developed for the measurement of interfacial shear viscosity.
综述测定界面剪切黏度的实验方法,重点介绍对其中几种常见实用的测定方法,包括这些测定方法各自的演变、测量原理、实验装置、灵敏度、优缺点等问题。
3.
The results showed that the apparent shear viscosity(ηa)and shear stress(τ)of all samples decreased with temperature increasing.
结果表明,随温度的升高,各试样的剪切黏度(ηa)和剪切应力(τ)下降;在250℃,剪切速率(γ)为200~10 000 s-1的条件下,各试样ηa和τ的差距逐渐缩小,流变曲线趋于重合。
补充资料：保险商实验室安全标准(见保险商实验室)
保险商实验室安全标准(见保险商实验室)
safety standards of UL: see Underwriters Laboratories; UL
Baoxianshang Sh啊nshi anquan bicozhun保险商实验室安全标准(saJ七ty stand助dsofUL)见保险商实脸室。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条