1) Tungalloy white cast iron
钨白口铸铁
2) Tungsten alloy white cast iron
钨合金白口铸铁
1.
Tungsten alloy white cast iron(TAWCI)has a low cost,but the application is limited owing to its high brittleness.
变质处理后,钨合金白口铸铁的共晶碳化物形态发生了显著变化,在常规热处理条件下,共晶碳化物变成了团球状,使之冲击韧性提高了72。
3) white cast iron
白口铸铁
1.
Effect of chromium alloying and complex modification on structures and properties of white cast iron;
添加铬合金化和复合变质处理对白口铸铁组织性能的影响
2.
An approach to improving anti-wear property of white cast iron;
改善白口铸铁抗磨性的途径
3.
The microstructure and mechanical properties of a new type wear-resistant white cast iron with the boride as wear-resistant phase were investigated.
研究以硼化物为耐磨相的新型耐磨白口铸铁的组织特点与力学性能。
4) White iron
白口铸铁
1.
Structure and corrosion behavior of the high silicon cast iron in several different environments have been tested by means of weight-loss analysis and metallograph,and compare the corrosion resistant of high silicon cast iron with common gray iron and white iron.
采用失重分析、金相分析等试验方法研究了高硅铸铁在不同环境下的耐腐蚀性能,并对高硅铸铁、普通灰铸铁及白口铸铁的耐腐蚀性进行比较。
2.
According to their matrix structure, the white irons are divided into ferrite white iron, ferrite-austenite white iron, austenite white iron, pearlite white iron and martensite white iron.
白口铸铁按基体分为铁素体白口铸铁、铁素体-奥氏体白口铸铁、奥氏体白口铸铁、珠光体白口铸铁和马氏体白口铸铁。
3.
By adjusting composition and adopting step quenching process,the hardenability of the medium chromium white iron was improved,its wear resistance is equivalent to that of the Ni-hard IV,and higher than Ni-hard I by20%～30%.
介绍了自行研制的中铬白口铸铁的成分、组织、性能。
5) CR15C3 white cast iron
Cr15C3白口铸铁
6) Vanadium white cast iron
钒白口铸铁
1.
The effect of hot deformation amount on impact toughness for Vanadium white cast iron was studied.
研究了热变形量对钒白口铸铁冲击韧性的影响。
补充资料：白口铸铁
在结晶凝固过程中没有石墨析出，断口呈银白色的铸铁。它含有较多的游离渗碳体，所以具有很高的硬度（一般在HB 500以上），但性脆。多用于抗磨损的零件，例如农具、磨球、磨煤机零件、抛丸叶片、泥浆泵零件、铸砂管以及冷硬轧辊的外表层等。以含碳量2.6～3.8％、含硅量0.6～0.9％、含锰量0.2～0.8％的铁水，加快铸件凝固过程，或加入强烈形成碳化物的金属元素的方法，可得白口铸铁件。中国早在春秋晚期已经使用白口铸铁（见冶金史）。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条