说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 补偿性能
1)  compensation performance
补偿性能
1.
Research on the compensation performance of three-phase four-wire active power filter with one-cycle control;
单周控制三相四线制有源电力滤波器的补偿性能研究
2.
Frequency-domain study of compensation performance of three-phase DC link active power filter
三相直流侧APF补偿性能的频域研究
3.
Based on several transfer functions of the output filter,the MATLAB was used to construct the simulation model to calculate the influence of output filter parameter fluctuations on the compensation performance.
分析了注入式混合型有源电力滤波器的工作原理,从几种常见的输出滤波器的传递函数出发,利用MATLAB建立输出滤波器参数的波动对补偿性能影响的仿真模型,发现LRC型输出滤波器在较低的开关频率下,获得比LCL和LC滤波器更优异的性能。
2)  characteristic compensation
性能补偿
1.
Thus it is essential to do the sensor characteristic compensation to make up for the measure error.
为此,本文针对飞控系统传感器存在的静态和动态误差,利用虚拟仪器技术在LabVIEW环境下设计了传感器性能补偿环节,开发了传感器信号处理平台,对信号进行时域测量、频谱分析、小波消噪、远程传输和网络发布等。
3)  performance compensating technique
补偿技术性能
4)  Error Compensation Performance
误差补偿性能
1.
For hidden-layer-growing construction method, the error compensation performance of hidden units and the sufficient and necessary condition for the optimal performance of hidden units were investigated by calculating their error compensation values.
通过计算隐单元的误差补偿值,对以隐层生长方式构建网络时,每个隐单元的误差补偿性能以及隐单元性能最优的充分必要条件进行了研究。
2.
The error compensation performance of the hidden unit was discussed according to the model of least-squares approximation feedforward neural networks using the method of subspace analysis,and further more,a hidden layer evaluation method was proposed.
针对最佳平方逼近3层前馈神经网络模型,采用子空间分析方法,讨论了隐单元的误差补偿性能,提出了隐层评测方法。
5)  intelligent compensation
智能补偿
6)  energy compensation
能量补偿
1.
A review of research on mechanism of seismic attenuation and energy compensation;
地震波衰减机理及能量补偿研究综述
2.
A method to measure the dosage rate by energy compensation to the detectors is mentioned.
提出了对探测器进行能量补偿测量剂量率的方法。
3.
The concept of energy control is presented and energy compensation control is applied to swing up the rotary inverted pendulum.
针对倒立摆的起摆控制,建立了环形单级倒立摆基于拉格朗日方程的运动方程,在此基础上提出了能量控制的概念,并将能量补偿控制应用在环形单级倒立摆系统上。
补充资料:不锈钢的物理性能、力学性能和耐热性能
不锈钢的物理性能


不锈钢和碳钢的物理性能数据对比,碳钢的密度略高于铁素体和马氏体型不锈钢,而略低于奥氏体型不锈钢;电阻率按碳钢、铁素体型、马氏体型和奥氏体型不锈钢排序递增;线膨胀系数大小的排序也类似,奥氏体型不锈钢最高而碳钢最小;碳钢、铁素体型和马氏体型不锈钢有磁性,奥氏体型不锈钢无磁性,但其冷加工硬化生成成氏体相变时将会产生磁性,可用热处理方法来消除这种马氏体组织而恢复其无磁性。

奥氏体型不锈钢与碳钢相比,具有下列特点:

1)高的电阴率,约为碳钢的5倍。

2)大的线膨胀系数,比碳钢大40%,并随着温度的升高,线膨胀系数的数值也相应地提高。

3)低的热导率,约为碳钢的1/3。

不锈钢的力学性

不论不锈钢板还是耐热钢板,奥氏体型的钢板的综合性能最好,既有足够的强度,又有极好的塑性同时硬度也不高,这也是它们被广泛采用的原因之一。奥氏体型不锈钢同绝大多数的其它金属材料相似,其抗拉强度、屈服强度和硬度,随着温度的降低而提高;塑性则随着温度降低而减小。其抗拉强度在温度15~80°C范围内增长是较为均匀的。更重要的是:随着温度的降低,其冲击韧度减少缓慢,并不存在脆性转变温度。所以不锈钢在低温时能保持足够的塑性和韧性。

不锈钢的耐热性能

耐热性能是指高温下,既有抗氧化或耐气体介质腐蚀的性能即热稳定性,同时在高温时双有足够的强度即热强性。

不锈钢国际标准标准

标准 标准名


GB 中华人民共和国国家标准(国家技术监督局)

KS 韩国工业标准协会规格Korean Standard

AISI 美国钢铁协会规格America Iron and Steel Institute

SAE 美国汽车技术者协会规格Society of Automative Engineers

ASTM 美国材料试验协会规格American Society for Testing and Material

AWS 美国焊接协会规格American Welding Society

ASME 美国机械技术者协会规格American Society of Mechanical Engineers

BS 英国标准规格British Standard

DIN 德国标准规格Deutsch Industria Normen

CAS 加拿大标准规格Canadian Standard Associatoin

API 美国石油协会规格American Petroleum Association

KR 韩国船舶协会规格Korean Resister of Shipping

NK 日本省事协会规格Hihon Kanji Koki

LR 英国船舶协会规格Llouds Register of Shipping
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条