1) Sliding mechanism
滑动机理
1.
The formation and sliding mechanism of Suigoupo landslide are nalyzed.
本文对水沟滑坡的形成及滑动机理进行了分析 ,对滑坡的稳定性进行了计算 ,得出不同状态下滑坡体的稳定系数及滑坡推力 ,并根据滑坡体与设计路线工程的关系 ,提出了在坡体中下部结合桥墩设置抗滑桩、坡体内及周界外设置截排水沟、坡面填坑埋缝的综合治理方
2.
In this paper, based on the investigations of an exploratory shaft and the mechanical testing of slip layer clay, the author analyzed the sliding mechanism and the stability before and after sliding of the Xintan slope, and pointed out that the slope may slide again.
本文在勘探竖井地质调查及滑移层取样力学试验基础上，对新滩滑坡的滑动机理及其滑前滑后的稳定进行分析，指出新滩滑坡在８５年６月大滑后，其再滑的隐患仍然存在，大滑的最主要触发因素是雨水对滑移层粘土强度的影响。
3.
This paper analyzes the sliding mechanism of the landslide based on the project geological condition,disease indication and monitoring data,determines the safety factor through the tensile force of the anchor stay,and proposes reinforcement measures.
根据此滑坡的工程地质条件、滑坡病害迹象以及监测资料,通过锚索拉力确定的滑坡安全系数,具体分析了滑坡的滑动机理,并提出了补强加固措施的方案。
2) deformation mechanism
滑动机理
1.
A study on deformation mechanism and prevention for a landslide in reservoir area of Three Georges;
长江三峡库区某滑坡滑动机理及稳定性研究
4) lube oil conditioner pump motor
润滑油处理泵电动机
5) engine lubrication schematic
发动机润滑原理图
6) lubricating mechanism
润滑机理
1.
Characteristics of lubricating mechanism of elastic metal-plastics bearing and its improvement;
弹性金属塑料轴承润滑机理的特点与改进方向
2.
In this article, the action of the lubricant to the coatings and its lubricating mechanism are introduced.
介绍了纸张涂料润滑剂对涂布纸的作用及其润滑机理 ,并对常用的几种润滑剂进行比
3.
The tribological characteristics of ultrafine WS2 powders in petrol engine oil have been investigated by four-ball machine test,and compared with chloroparaffins(T302) and molybdenum disulphide(MoS2),meanwhile the tribochemical species of the worn surface by means of X-ray Photoelectron Spectroscope(XPS) have been analyzed to research the lubricating mechanism of WS2.
通过四球摩擦实验机考察了超细二硫化钨粉末在汽油机油中的摩擦学性能,并与氯化石蜡(T302)、二硫化钼进行比较,同时用X射线光电子能谱仪对磨痕表面元素进行分析,探讨二硫化钨的润滑机理。
补充资料：腹股沟滑动性疝修补术
腹股沟滑动性疝修补术
repair of sliding inguinal hernia
滑动性疝均应手术修补。一般采用经腹股沟修补术。麻醉、切口和显露疝囊的手术步骤与斜疝手术相同。显露疝囊并切开，然后在滑出内脏(例如盲肠)的周围约1.5cm处作一环形切口，切开腹膜(即疝囊)，在腹膜外游离盲肠，直至疝囊颈部(内环)外。注意勿损伤肠管的动、静脉。将游离的盲肠显露于切口外，在其后面将两侧腹膜作间断对合缝合，使其成为一个新的完整疝囊。然后，将游离的盲肠回纳入腹腔，在内环外用丝线作一荷包缝合，以关闭腹腔，剪除多余疝囊。然后施行Bassini或McVay术修补腹股沟管。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条