说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 车辆振动荷载
1)  traffic loading
车辆振动荷载
1.
The pore water pressure of hydraulic fill in Shanghai Newport town was studied in this paper when the roadbed deformed & liquefied under the traveling traffic loading.
以上海临港新城冲填土地层分布区的道路在车辆振动荷载作用下路基变形、破坏时孔隙水压力发展规律为研究对象,以不同的振动频率和动应力来模拟车辆振动荷载,进行了振动三轴试验研究,试验结果表明:在相同固结比,不同振动频率和振幅情况下,孔隙水压力随着振动次数的增加而增大,在开始振动的前一段时间,孔隙水压力增加较快,但当振动次数比达到0。
2)  vehicle dynamic load
车辆动荷载
1.
In order to simulate the vehicle dynamic load caused by road roughness and analyze the dynamic response of pavement in the vehicle-road or vehicle-bridge interaction system more precisely,the definitions of road roughness were reviewed.
为了在车-路或车-桥相互作用的耦合体系中更准确地模拟由路面不平整度引起的车辆动荷载,以及分析由动荷载引起的路面动响应,论述了路面平整度的各种定义,回顾了路面平整度的各项评价指标、评价方法及各种评价指标之间的关系。
2.
To get a comprehensive analysis of dynamic characteristics, the vehicle dynamic load and the criterion of calculation as well as the dynamic response characteristics of the bridge-approach pavement are investigated in this paper by theoretical research, numerical modeling and spot investigation.
为了全面分析路桥过渡段动力特性,本文基于现场调查、理论分析和数值计算,研究车辆动荷载的变化规律和计算标准以及车辆荷载作用下路桥过渡段路面的动态响应特性,主要研究内容和成果如下:1。
3)  moving vehicle loads
移动车辆荷载
1.
Under moving vehicle loads,the histories of bending moment at different sections and mode curves of continuous girder bridge are given.
参照简化的车辆模型和桥梁模型建立车-桥相互作用的数学模型,给出在移动车辆荷载作用下连续梁桥各截面动力响应的时程曲线和连续梁桥前几阶模态的振型曲线,研究表明,连续梁桥各控制截面起主要作用的模态并不都一样;另外,数值分析表明,对于连续梁桥,冲击系数公式仅考虑桥梁第一阶频率是不合理的。
4)  car load
机动车辆载荷
5)  dynamic response due to moving vehicle
车辆动荷载响应
6)  vehicle load
车辆荷载
1.
Active earth pressure induced by saturated subgrade under vehicle load;
车辆荷载下饱和路基挡墙主动土压力计算
2.
Analysis of efficiency of vibration isolating groove subjected to vehicle load;
车辆荷载作用下隔震沟隔震效率影响因素分析
3.
Numerical simulation of failure mechanism of subgrade retaining structure under vehicle load;
车辆荷载下路基挡土结构失稳机理数值模拟
补充资料:点振子振动和点电极振子振动
分子式:
CAS号:

性质:又称点振子振动和点电极振子振动。振动能量绝大部分集中在点电极范围内,形成“能量封闭”的振动模式。振子电极面远小于压电陶瓷片的总面积,且与厚度有适宜的匹配关系。在交变电场作用下,沿厚度方向产生振动,其振幅随着至电极中心距离的增加,呈指数式衰减。谐振频率与压电陶瓷片的厚度有关。为提高频率通常将压电陶瓷片磨得很薄,有时考虑到压电陶瓷自身强度太低,可用特制的陶瓷片作垫片来防止压电陶瓷片损坏。常用于高频场合。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条