说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 压力瞬态脉动
1)  pressure transient pulsation
压力瞬态脉动
2)  transient pulse technique
瞬态压力脉冲法
3)  flow pressure/[instantaneous state]
流动压力/[瞬态]
4)  transient pressure
瞬态压力
1.
Research on frequency response of the transmission line during the measurement of transient pressure;
瞬态压力测量中传压管道频率特性分析
2.
By employing the finite element method, and in combination with the process of functionally gradient materials, the transient pressure within metal/ceramic particles impacting onto a substrate is studied.
采用有限元数值模拟方法 ,研究功能梯度材料中金属 /陶瓷熔融颗粒高速碰撞到基体后的瞬态压力分布、变化过程及其影响因素 。
3.
The transient pressure, pressure recovery time and hydrocarbon gas concentration during fuel tank damaging process by fragments of W-Zr alloy, 93W alloy and fragile tungsten alloy were studied.
7mm弹道枪发射破片进行模拟穿靶试验,对钨锆合金、93钨合金和易碎钨合金3种材料破片在毁伤油箱过程中的瞬态压力、压力恢复时间和油箱内烃气浓度进行研究。
5)  pressure transients
压力瞬态
1.
In order to predict pressure transients accompanied with cavitation and gas bubbles inside low pressure hydraulic pipeline,a new method using improved genetic algorithms(GAs) in parameter identification of pressure transient models is presented in this paper.
为了合理预测伴随气泡和气穴的低压液压管路压力瞬态脉动,提出了用改进遗传算法对低压液压管路压力瞬态脉动模型进行参数辨识的新方法。
6)  pressure transient
压力瞬态
1.
The mathematical models of the pressure transient state of the pipes and components, such as the accumulator, the proportion valve, the supercharger etc.
介绍了一种用于航空液压系统管路与元件压力脉冲试验的设备,建立了试验系统的压力瞬态模型,分析了影响脉冲波形的因素,给出了梯形波和水锤波的控制方法。
补充资料:脉动压力


脉动压力
fluctuating pressure

maidong yali脉动压力(fluetuating pressure)由f高速水流的强烈紊动,在建筑物表面产生的围绕时均压强上下波动的随机动水压力。作用于泄水或放水建筑物表面上的脉动压力,除可能引起空蚀外,对有些建筑物,如溢流式水电站厂房的溢流顶板、护坦、闸墩等,还可能引起振动。当脉动压力的振动频率与建筑物自振频率一致或接近时,可能产生共振,从而导致建筑物破坏。 对于高大的水工建筑物在高速水流作用下的脉动压力,最好通过水工模型试验进行研究。试验中测出的点脉动压力在时均压强线上下呈不规则的波动变化,可用谱分析方法寻求波动的随机特性(振动频率、脉动压力的最大振幅值等)。由于脉动压力试验的模型相似律迄今还未成熟,压强的测量技术也还不够完善,因此,试验结果也并不完全准确。当无试验资料时,只能用简单方法进行粗略估算。例如同一时刻作用在护坦L的点脉动压力强度和方向很不相同,虽然点脉动压力值可能很大,但平均到护坦板上的面压力值并不大,故可采用下式估算:几一士。二理一:、吨/米2, ‘g式中砰为收缩断面的平均流速(米/秒);g为重力加速度(米/秒“);了为水的容重(吨/米“);a,为脉动压力系数。am介于0.05一0.1之间,可根据水流的缓急程度适当选用。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条