1) backlash voltage
回差电压
2) hysteresis voltage method
回差电压法
1.
n this paper, we take the 40Wp user photocell source system controller for example, mainly discuss the cause for oscillation and its solving method in the control circuit designed to protect storage battery from overcharge and overdischarge, this is called hysteresis voltage method, describe the design main idea and operating principle, give a simple and utility diagram.
以４０Ｗｐ户用光伏电源系统控制器为例，探讨了为防止蓄电池过充电与过放电而设计的控制器电路产生振荡的原因及解决方法——回差电压法，简述了该方法的设计思想及工作原理，给出了简单实用的电路图。
3) voltage hysteresis comparators
电压回差比较器
1.
In this paper,the progress was made that high and low thres holds of voltage hysteresis comparators were adjusted alone.
对电压回差比较器实现上下门限独立调节的原理作了进一步研究 ,给出了理论推导及稳定性分析。
4) the differential-voltage protection
差压回路
1.
This paper points out the influence on the start-up circuit of the differential-voltage protection when the capacitor s primary connec- tion is changed.
阐述了电容器一次主接线改变后对其二次差压回路造成的影响,以及对差压二次回路的改进措施。
5) B.D (blowdown difference between the opening and closing pressure)
回座压差
6) Differential pressures to oil
压差回油
补充资料：回差
分子式：
CAS号：
性质：也称仪表的变差。在仪表全部测量范围内，被测量值上行和下行所得到的两条特性曲线之间的最大偏差。它包括滞环和死区。
CAS号：
性质：也称仪表的变差。在仪表全部测量范围内，被测量值上行和下行所得到的两条特性曲线之间的最大偏差。它包括滞环和死区。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条