说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 空气阻尼
1)  air damping
空气阻尼
1.
The distance between the mass and the glass cover is 5 μm which is controlled by the silicon-glass bonding technique,and it not only provides optimal air damping for the system but also has overloading protection effect.
该结构采用硅玻键合技术控制质量块下底面到玻璃底盖的间距为5μm,为系统提供空气阻尼使其处于最佳阻尼状态,同时玻璃底盖起到了过载保护作用,仿真分析表明该结构可承受200000 gn的加速度载荷。
2.
To research the effect of air damping on resonators, based on the Euler-Bernoulli assumption, beam vibration mechanism and air damping theory, a vibration equation was established and its solution was obtained according to corresponding boundary conditions.
为了研究空气阻尼对谐振器工作性能的影响,基于Euler-Bernoulli假设、梁弯曲振动理论和气体阻尼理论,建立了考虑气体阻尼的梁振动方程,结合边界条件对方程进行了求解,得到了两种不同情况下气体阻尼对微梁谐振器的谐振频率和品质因子的影响。
3.
in the scaling of seismic geophone,the air damping will be too large to measure D 10 accurately,thus causing S1,a12,RD,and C all inaccurate.
在拾震器的标定过程中 ,当 Ri≤ 1 0 MΩ 时 ,空气阻尼太大 ,所测定的 D10 结果不准确 ,从而导致 S1、a12 、RD 以及 C、β12 均不准确 ,所得 V也不准确 ,同时记录地震的波形也会受到影响 ,为此建议在标定和工作时 ,要串上分压电阻 R,以此为导向使得放大器输入电阻 Ri≥1 0 MΩ时 ,所得结果才能符合规范要求 ,本研究通过多次测试均达到良好的效果。
2)  gas damp
空气阻尼
1.
The dynamic model for the micro switch including the permanent magnetic force,the gas damping force,the contact force and the inertia force is established.
对开关工作过程中质量块位置、永磁力、空气阻尼力、质量块与触点接触力等参数的变化规律进行了仿真,结果表明:该设计可以受控于加速度门限完成闭合-断开功能;微开关系统阻尼由质量块与封装外壳间隙厚度决定,为一变阻尼系统;开关闭合时电接触可靠性取决于质量块对触点的压力;开关闭合和截止所需的激励加速度门限值受永磁铁磁力和支撑梁刚度参数的控制。
2.
The gas damp of the two translational moving parallel flats in Micro Electro-Mechanical System (MEMS) devices is analyzed.
针对微电子机械系统中平行板间的气膜阻尼问题,通过将平板沿垂直方向的位移运动方程展开为傅里叶级数,得到了微平面机构所受的空气阻尼力和阻尼系数的解析公式。
3)  airdamper
空气阻尼器
4)  Squeeze-film air damping
压膜空气阻尼
1.
Squeeze-film air dampings of thick perforated microstructures with hole arrays in different forms have been studied analytically and numerically by changing the shapes of holes and the areas of hole cells.
本文对微结构上孔的形状和排列方式对压膜空气阻尼的影响进行了理论和模拟分析。
2.
A differential equation for calculating squeeze-film air damping in slotted plates is developed by modifying the Reynolds equation.
推导出了一个适用于槽板结构压膜空气阻尼的微分方程。
5)  air damping model
空气阻尼模型
1.
An air damping model is developed for studying the free vibration of office paper.
研究了办公设备纸张在自由振动过程中的阻尼特性 ,建立了针对纸张振动问题的空气阻尼模型 。
6)  air spring damper
空气弹簧阻尼器
补充资料:单位阻尼能
分子式:
CAS号:

性质:变形周期中损失的能量与材料体积之比。亦称之为单位阻尼能。高分子材料具有黏弹性,发生变形时不是完全的弹性变形,而伴随着发生塑性变形。在发生塑性变形时,由于分子间或晶面间的滑移,摩擦生热等耗去了能量,因此不能使原加的能量完全以形变能贮存,并在恢复过程中释放。失去的那部分能量就属于能量损耗。正确了解这一点,就可以根据不同用途来进行选材,也对新材料的研究起指导作用。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条