说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 直线伺服电动机
1)  Linear servo motor
直线伺服电动机
2)  linear servo motor
直线伺服电机
1.
An integrated design scheme of linear servo motor and cryocooler with dual-linear motor driving the compressor,resulting in remarkable advantages of smaller volume,less vibration,longer service life was introduced.
介绍了一种采用直线伺服电机与斯特林制冷机一体设计的方案,双直线电机对动驱动压缩机,使制冷机具有体积小、振动轻、寿命长的显著优点。
2.
as an example,introduces the work principle,the classification and the construct of the linear servo motors.
介绍了伺服用直线电动机的原理、种类、构造、应用领域和KOLLMORGEN及BALDOR公司的部分商品直线电机的典型参数 ,可供新的自动化装置研发过程中应用直线伺服电机时参
3.
A converting circuit was proposed based on frequency-multiplier circuit for linear servo motor and PLC interface.
提出了一种基于倍频电路的直线伺服电机与PLC接口转换电路。
3)  DC servo motor
直流伺服电动机
1.
In order to decreasing of volume and improving of reliability of servo systems, a solution of DC servo motor driver based on LMD18200T is designed in this paper.
为了减小伺服系统体积,提高其可靠性,设计了一种基于LMD18200T组件的直流伺服电动机驱动器的解决方案。
2.
In this paper, the SIMPLORER 5 0 is used, which is a kind of simulation software produced by ANSOFT, to simulate and analyze the speed fluctuation and the character of the step response and frequency reponse of a kind of DC servo motor used in the CT table under different driving method.
0 ,对一种 CT扫描床用直流伺服电动机在不同驱动方式下的转速波动、阶跃响应和频率响应特性进行了仿真和对比分析。
4)  antenna servo motor
天线伺服电动机
5)  linear servo motor operating mechanism
直线伺服电动机操动机构
1.
Single neuron PID (Proportional Integration Differential) controller used in high voltage circuit breaker linear servo motor operating mechanism is designed.
高压断路器直线伺服电动机操动机构采用直线电动机驱动断路器操作杆,带动机构运动,实现分合闸操作,具有良好的快速响应能力及控制性能。
6)  linear DC servo motor
直流直线伺服电机
补充资料:伺服电动机
伺服电动机
servomotor
    用作自动控制装置中执行元件的微特电机。又称执行电动机。其功能是将电信号转换成转轴的角位移或角速度。
   伺服电动机分交、直流两类。交流伺服电动机的工作原理与交流感应电动机相同。在定子上有两个相空间位移90°电角度的励磁绕组Wf和控制绕组WcoWf接一恒定交流电压,利用施加到Wc上的交流电压或相位的变化,达到控制电动机运行的目的。交流伺服电动机具有运行稳定、可控性好、响应快速、灵敏度高以及机械特性和调节特性的非线性度指标严格(要求分别小于10%~15%和小于15%~25%)等特点。直流伺服电动机的工作原理与一般直流电动机相同。电动机转速n
   nEK1j=(UaIaRaK1j式中E为电枢反电动势;K为常数;j为每极磁通;UaIa为电枢电压和电枢电流;Ra为电枢电阻。改变Ua或改变φ,均可控制直流伺服电动机的转速,但一般采用控制电枢电压的方法。在永磁式直流伺服电动机中,励磁绕组被永久磁铁所取代,磁通φ恒定。
   直流伺服电动机具有良好的线性调节特性及快速的时间响应。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条