说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 结点转角传递
1)  node rotational angle transfer
结点转角传递
2)  Transitive roles
传递角色
3)  vertex-transitive graph
点传递图
1.
In this paper,we prove that a connected cubic vertex-transitive graph of order 2p~2(p a prime)is either a Cayley graph or isomorphic to the generalized Petersen graph p(p~2,t), where t~2≡-1(mod p~2
一个图称为点传递图,如果它的全自同构群在它的顶点集合上作用传递。
2.
In fact, researching the symmetry property of the Coset graph is more significant than the Cayleygraph, because every vertex-transitive graph is always some Coset graph of its full automorphism group.
关于陪集图对称性的研究其实较Cayley图更具有普遍的意义,因为任何一个点传递图都是其全自同构群的某个陪集图。
3.
In fact, researching the symmetry of Sabidussi coset graphs has more general significance than doing so for the Cayley graph because every vertex-transitive graph is always some coset graph of its full automorphism group.
关于陪集图对称性的研究其实较Cayley图更具有普遍的意义,因为任何一个点传递图都是其全自同构群的某个陪集图。
4)  transmission zeroes
传递零点
5)  vertex-transitive
点传递
1.
Firstly,we obtain some equivalent characterization for Cayley graphs of completely simple semigroup which is vertex-transitive.
得到了完全单半群的Cayley图的弱点传递性的等价条件,给出了半群的Cayley图是自同构弧传递的充分必要条件,特别地,完全刻画了带的Cayley图的自同构弧传递条件。
2.
Secondly,we give a sufficient condition for the cyclic optimality of vertex- or edgetransitive graphs,that is:any connectedκ-regular vertex-transitive graph with k≥4 and girth at least five is cyclically optimal;any connected edge-transitive graph with minimum degree at least four and order at least six is cyclically optimal.
本论文分别给出点传递图和边传递图是最优圈边连通的一种充分条件,即:任意一个连通κ-正则点传递图若满足κ≥4且围长g≥5,则它是最优圈边连通图;任意最小度δ(G)≥4且点数n≥6的边传递图是最优圈边连通图。
6)  point-transitively
点传递
1.
If Sz(q)≤G≤Aut(Sz(q)),where q=22n+1,then G cannot act point-transitively on S.
若对某q=22n+1,使Sz(q)≤G≤Aut(Sz(q)),则G不能点传递地作用于S上。
2.
It is proved that if Soc(G)=Ree(q),where q=32n+1 and n>0,then G cannot act point-transitively on a finite projective plane.
如果G≤Aut(D)且Soc(G)=Ree(q),这里q=32n+1,n>0,则G不能点传递作用在D上。
补充资料:点接触结(pointcontactjunction)
点接触结(pointcontactjunction)

简便的方式是将超导体一削尖的端点(约0.1μm端径)施压在另一超导体小面上而接触成点接触结,它是一种弱连接。由于压力可调节,就可选择最好所需最适宜接触性能。点接触结可用于制作磁强计和微波接收与发射等装置。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条