1) large strain theory
大变形理论
1.
The consolidation settlement of the dredger fill under deadweight in Lingangxincheng area of Shanghai is studied using large strain theory and a centrifuge model test.
基于大变形理论和离心模型试验对上海临港新城地区冲填土自重固结沉降进行分析研究。
3) Gibson's large-strain consolidation theory
Gibson大变形理论
4) large deformation-strain theory
大变形-大应变理论
5) deformation theory
形变理论
1.
HT5SS]The method of fast finite element analysis of sheet metal forming based on deformation theory was explored, and the computer program was implemented.
研究了基于形变理论的金属板料成形快速有限元分析的方法——反向方法 ,并实现了计算程序。
2.
The theory and method of finite element analysis of sheet metal forming based on deformation theory was explored, and the computer program was implemented.
研究了基于形变理论的金属板料成形有限元分析的理论和方法，并实现了计算程序。
3.
The residual stress around a coldworked hole is computed with elasto-plastic finite element methods of both flow theory and deformation theory.
本文为了检验形变理论在计算钉孔挤压残余应力场的可用性,对同一模型分别釆用全量法和增量法进行有限元计算,计算结果表明:在小的挤压量下,即δ≤2％(挤压量δ定义为(D_棒-D_板)/D_板×100％),两种方法均可釆用,当挤压量较大,即δ>2％时,全量法的结果与边界条件吻合得不好,而增量法符合得很好。
6) Deformation Theory
变形理论
1.
The reality results was compared with the calculating ones which were obtained by using small deformation theory,energy analytic method and big deformation theory.
介绍球形封头在外压下的失稳计算 ,应用小变形理论、能量分析法和大变形理论公式所计算的结果与实际结果相比较 ,探讨失稳安全系数的基
2.
The prebuckling deformation theory under axial pressure,lateral pressure or liquid pressure is presented.
应用复合材料理论 ,采用扁壳模型 ,在弯曲变形与薄膜变形耦合的本构方程情况下 ,同时考虑了简支和固支边界条件 ,对纤维缠绕圆柱壳的前屈曲进行了分析 ,建立了壳体在端部受均匀轴压、侧压或流体压力情况下的前屈曲变形理论 ,并获得了相应的数值计算结
3.
Generalized simulated potential energy principles and generalized simulated complementary energy principles, including the conditions of incompressibility of the volume, of similarly non -coupled systems for deformation theory and flow theory in plasticity are proposed
提出了塑性力学变形理论和流动理论包括体积不变条件的相似非耦联系统的广义模拟势能原理和广义模拟余能原理
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条