1)  biaxial tension
二轴拉伸
2)  two-shaft
二轴
1.
The article introduces the experience of SMW engineering process used in the projects in Shanghai Pudong Area, and discusses the gist problems of two-shaft, three-shaft SMW engineering process in the design and construction of this engineering process.
该文介绍了上海浦东地区工程中采用SMW工法的经验,论述了该工法设计施工中二轴、三轴SMW工法的要点问题。
3)  two-axial continuous path control
二轴联动
1.
Design of plane position controlling system by two-axial continuous path control;
二轴联动位置控制系统的设计
4)  paralleled triple casing pipe type
二轴一径
1.
The flow sheet and structure of 2 axial and 1 radial type and paralleled triple casing pipe type inner parts of converter are introduced.
介绍二轴一径和并流三套管式氨合成塔内件流程和结构 ,对两种内件的应用情况进行了对比。
5)  Biaxial stress
二轴应力
1.
Biaxial stress of ferromagnetic materials and residual stress of welding components have been measured by using the relation between Barkhausen effeet based on the law of approach to saturation magnetization and internal stress.
利用该技术，以近饱和磁化产生的巴克豪森效应与应力的关系，测量了铁磁构件的二轴应力和焊接构件的残余应力。
2.
According to the biaxial stress condition of the concrete pipe and it s possible failure analysis in construction phase and use phase, the limite of one - off concrete - pour height in the concrete pipe is obtained, and a equation is presented for gene.
通过对拼装块在施工和使用阶段可能发生的破坏和二轴应力状态的分析,从裂缝控制的角度对施工中混凝土的一次性浇筑高度作了规定,并给出了一般性的计算公式。
6)  biaxial anisotropy
二轴参量
1.
A circuit model of ferroelectric liquid crystal(FLC) was proposed to study the effects of biaxial anisotropy on switching time,characteristic time,characteristic voltage and polarization reversal current,and those of ferroelectric torque and dielectric torque on light transmittance.
模拟分析显示,延迟时间随驱动电压幅度变化存在最小值,特征时间(特征电压)随二轴参量的提高而增加(减小)。
参考词条
补充资料：单轴拉伸薄膜
分子式：
CAS号：

性质：在某一轴向经高倍拉伸过的高分子薄膜。在连续化生产中这个轴向就是牵引方向。这种薄膜沿拉伸方向的断裂强度(纵向强度)得到很大的提高，但在膜平面内垂直于拉伸方向的强度(横向强度)则明显降低。在特殊情况下，当拉伸倍数很高时，横向强度非常低，薄膜很容易顺纵向撕裂。故通常把这种特殊的单轴拉伸薄膜称为撕裂膜。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。