1) part time-resident interference
部分驻留时间干扰
1.
Therefore,based on researching FH communication systems,the influence of part time-resident interference on FH communication s synchronization and its tracking has been mainly analyzed.
为此,在对跳频通信系统研究基础上,重点分析了部分驻留时间干扰对跳频通信系统同步及跟踪的影响。
2.
Therefore,based on the research on FH/DS communication systems,the in?uence of part time-resident interference on FH/DS communication system synchronization is analyzed in this paper.
为此,在对FH/DS通信系统研究基础上,重点分析了部分驻留时间干扰对FH/DS通信系统同步的影响。
3.
Based on feasibility analysis of detecting and receiving FH synchronous signals and localization analysis of current method to jam FH synchronous signals,a new jamming method——part time-resident interference was put forward,and the ratio of jamming-to-signal time-resident was regarded as another important index to jam FH synchronous signals.
在分析了跳频同步信号侦收的可行性及目前干扰跳频同步信号方法的局限性的基础上,提出了一种新的干扰方法——部分驻留时间干扰,并将干信驻留时间比作为影响跳频同步信号的又一重要指标。
2) ratio of jamming-to-signal time-resident
干信驻留时间比
1.
Based on feasibility analysis of detecting and receiving FH synchronous signals and localization analysis of current method to jam FH synchronous signals,a new jamming method——part time-resident interference was put forward,and the ratio of jamming-to-signal time-resident was regarded as another important index to jam FH synchronous signals.
在分析了跳频同步信号侦收的可行性及目前干扰跳频同步信号方法的局限性的基础上,提出了一种新的干扰方法——部分驻留时间干扰,并将干信驻留时间比作为影响跳频同步信号的又一重要指标。
3) resident time
驻留时间
1.
Analysis on resident time and detection performance of tong detector
唐检测器的驻留时间及检测性能分析
2.
Then,according to the simulating results,polishing correction was accomplished after adjusting the function of tool resident time.
对计算机控制小磨头抛光的材料去除作用进行了计算机模拟;依据计算机模拟结果,调整驻留时间函数,进行抛光补偿;最后,在自行研制的三轴联动非球面数控抛光原理样机上高效地完成了70 mm左右非球面的抛光,各项指标达到了中等精度要求,表面粗糙度为2。
3.
The resident time algorithm was presented and proved to be convergent by the simulation machining experiment.
建立了磁流变抛光球形光学元件的去除模型,分析了影响磁流变抛光的因素,提出了驻留时间算法,用其仿真加工球形工件,结果表明该算法是收敛的,并用磁流变抛光加工了R41。
4) dwell time
驻留时间
1.
Specification of dwell time in discrete-time linear switched systems with state delays under cyclic switching;
离散线性循环切换时滞系统驻留时间的确定
2.
A dwell time algorithm for the magnetorheological finishing (MRF) of the small axis-symmetrical aspherical surfaces is described.
介绍了一种基于代数算法的回转对称非球面计算机控制表面成形的驻留时间算法。
3.
According to FP-tree,a Frequent Page Tree structure with Dwell Time(abbreviated as FPDT-tree) is designed.
由于一定时间段的会话中蕴含着用户的访问模式与访问动机,设计一种结点带有驻留时间,类似FP-tree的频繁页面树FPDT-tree结构;利用FPDT-tree结构存储双向驻留时间约束的会话数据库,简化挖掘过程中驻留时间阈值的设置。
5) resident section
驻留部分
6) short dwell time
短驻留时间
补充资料：白陶土部分凝血活酶时间
白陶土部分凝血活酶时间
kaolin partial thromboplastin test,KPTT
检查内源凝血系统全部凝血因子的一种敏感的过筛试验。故内源性凝血过程中的任何因子有缺陷时，其生成时间均可延长。试验时，在血浆中加入脑磷脂和白陶土。脑磷脂代替血小板和加速因子Ⅹ活化的作用，白陶土能充分激活因子Ⅶ和Ⅸ，这样缩短了血浆凝固时间，血浆与上述悬液混合后，温育一定时间使凝血因子活化，然后加入氯化钙测定血浆凝固时间，即为白陶土部分凝血活酶生成时间。延长见于Ⅷ、Ⅸ、Ⅶ、Ⅵ因子缺乏及Ⅱ，Ⅴ因子、纤维蛋白原明显减少。缩短见于因子Ⅷ及因子Ⅴ增多，播放性血管内凝血高凝血期及血小板增多症。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条