1)  circulating current
护层电流
1.
With the development of urban construction, renovation of the power cable is becoming increasingly frequent, which often causes the length of three segments to be unequal, bringing about unbalanced induced voltage in the metal shield and the circulating current in the metal shield.
文中通过对电缆护层电压的理论分析,推导了电缆任意排列方式下的护层感应电压的计算模型;提出了在电缆终端加补偿装置的方法来平衡护层电压,抑制护层电流
2)  sheath
护层
1.
The principle and analysis of sheath grounding and application of grounding way in practical running of cable were also introduced.
阐述了单芯电缆的结构及各部分的主要作用,分析了护层接地的原理,介绍了此接地方式在邯钢电缆线路上的实际运行。
2.
Accuracy of the existing sheath fault distance measurement methods is subject to test lead and contact resistance influence, and therefore is not satisfactory for practical fault location application.
35KV以上高压单芯电缆护层绝缘破坏是一种比较常见的故障现象,目前的护层故障测距方法精度受导引线及接触电阻影响比较大。
3)  protective layer
保护层
1.
The effect of reinforced protective layer and its control;
对钢筋保护层作用及控制的认识
2.
Analysis of the effect of protective layer thickness on the performance of RC eccentric compressive member;
保护层厚度对混凝土偏压构件性能影响分析
3.
Based on engineering example of protective layer mining in Hongling coal mine of Shenyang Coal Group,the mining-induced fracture distribution has been studied.
以沈煤集团红菱煤矿保护层开采为工程实例,通过开采11#煤层,对存在煤与瓦斯突出的7#煤层和12#煤层进行卸压,研究保护层开采后采动裂隙分布规律。
4)  protective seam
保护层
1.
Design methods of the effective water-resisting thickness for the protective seam of the water barrier in fully-caving mechanized coal mining;
综放开采防水煤岩柱保护层的“有效隔水厚度”留设方法
2.
To seek the technique method for mining the thick seam in high gas and outburst mine safely and effectively,experimental researches are carried out on the laws of gas emission coal roadways such as protective seam,protected seam and beforehand drainage seam while excavating in the thick seam at the same area in high gas and outburst mine,and the causes are anslyzed.
为了寻求一套适合高瓦斯突出矿井厚煤层开采的技术方法、实现安全高效回采,研究了高突矿井同一区段厚煤层保护层、被保护层与先抽后采煤层三种情况下煤巷掘进期间瓦斯涌出规律,对比分析了各巷道瓦斯涌出差异的原因。
3.
0~(2D) finite element numerical simulation,it has proved that the pressure of overlying coal seam far away from the protective seam can be completely relaxed after the protective seam has been mined out.
02D有限元数值模拟研究方法,对煤层下保护层开采卸压效应进行了模拟研究。
5)  Protective Coating
保护层
1.
Simple talking about the disabled problems of the protective coating in reinforced concrete components;
浅谈钢筋混凝土构件保护层的失效问题
2.
A study of the relationship between the thickness and strength of the concrete protective coating;
混凝土保护层厚度与强度关系的研究
3.
Combining the construction practice of many years, the article elaborates on the importance of steel protective coating and the control of its thickness in construction according to the common power mechanisms of steel and concrete.
从钢筋与混凝土共同作用的受力机理,结合多年的施工实践,对钢筋保护层的重要性及其厚度在施工中的控制做了简单的阐述。
6)  protective layer
防护层
1.
Adhesion performance and corrosion resistance properties of two kinds of protective layers on 45# steel were researched.
研究了45#钢表面两种防护层的结合性能和耐蚀性能。
2.
The wall of archives storehouse is a compound wall consisting of waterproof layer (outside) + protective layer + damp course + thermal insulation layer+ heat accumulation layer + interior decorative surface (inside).
档案库房的墙体是一个由 (外侧 )防水层 +防护层 +防潮层 +绝热层 +蓄热层 +内饰面 (内侧 )组成的复合墙体。
参考词条
补充资料:标准冲击电流波形(见冲击电流发生器)


标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form

  blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。