1) uneven wear
偏磨损
1.
With a tire uneven wear model and composite suspension dynamic model combined,a suspension-tire-ground dynamic system was developed to analyze composite suspension tire uneven wear.
通过将轮胎偏磨损物理模型和轿车复合式悬架动力学模型结合起来,建立了可用于动态分析复合式悬架轮胎偏磨损的悬架-轮胎-地面动力学系统。
2) uneven wear mechanism
偏磨损机理
3) uneven wear of tire
轮胎偏磨损
4) partial abrasion
偏磨
1.
Influence of resonance on the partial abrasion of rod string in screw pump well;
共振对螺杆泵井抽油杆偏磨的影响
2.
Study on partial abrasion protector for sucker rod string;
抽油杆柱防偏磨器的研究
3.
Dynamics analysis on partial abrasion and fracture of driving rod in screw pump wells;
螺杆泵井驱动杆柱的偏磨和断裂动力学分析
5) eccentric wear
偏磨
1.
Comprehensive control of eccentric wear of sucker rod and tubing in rod pumped wells in Shuanghe Oilfield;
双河油田有杆泵井管杆偏磨的综合防治
2.
The result shows that the eccentric wear of tubing greatly decreases the deformation resistibility capacity and the two-side eccentric wear of tubing leads to more serious tubing failure.
为了解决油管偏磨问题,对内压和轴力作用下的无偏磨、单面偏磨和双面偏磨油管分别进行了有限元(AN-SYS软件)模拟研究。
3.
The casing eccentric wear often occurred in deep and ultra deep well exploitation.
随着油田开采的不断深入,应用于深井、超深井的套管经常发生偏磨现象。
6) partial wear
偏磨
1.
In Xia 52 block of Linnan oilfield,the problem of sucker rod partial wear becomes very serious.
临南油田夏52块油井杆管偏磨问题比较严重,直接影响着油井的正常生产,消除和减少杆管磨损已成为油井管理的重点。
参考词条
补充资料：表面磨损
分子式：
CAS号：
性质：两表面接触并作相对运动所产生的微弱摩擦导致了缓慢的材料消耗。根据相对运动的特点，分成滑动磨损，转动磨损，冲击磨损三种。通常认为接触压力较小，表面材料消耗不大的属表面磨损，相反的情况，可归入表面磨耗。
CAS号：
性质：两表面接触并作相对运动所产生的微弱摩擦导致了缓慢的材料消耗。根据相对运动的特点，分成滑动磨损，转动磨损，冲击磨损三种。通常认为接触压力较小，表面材料消耗不大的属表面磨损，相反的情况，可归入表面磨耗。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。