1) variant design of process
工艺变型
1.
Finally integrated part modeling supporting variant design of process is described.
文章提出了面向工艺变型设计的产品建模方法;详细介绍了支持工艺变型设计的零件模型的组成结构和零件各种模型的建立方法;最后对支持工艺变型设计的完整的零件模型进行了描述。
2) modified CASS
CASS变型工艺
1.
This paper deals with a modified CASS(cyclic activated sludge system)process in treating beer brewery wastewater,focusing on coping with sludge baulking.
在CASS变型工艺处理啤酒废水的可行性研究阶段,由于某种原因造成了污泥膨胀现象,影响了工艺的正常运行。
3) deformed process design
变型工艺设计
4) new modified two bath process
变型二浴法新工艺
5) deformation process
变形工艺
1.
Effect of deformation process on superplasticity of TC11 titanium alloy
变形工艺对TC11钛合金超塑性的影响
2.
The effect of deformation process parameters on microstructure and mechanical properties of as-hot rolled Si-Mn dual-phase steel were studied by controlled rolling and controlled cooling test.
以热轧Si-Mn系双相钢为研究对象,在实验室通过控制轧制和控制冷却实验,研究了变形工艺参数对高强热轧双相钢显微组织和力学性能的影响。
3.
The relationship of the heat deformation processes of the antirust aluminum alloy LF6 and its microstructure were studied.
研究了防锈铝合金LF6热变形工艺对组织的影响。
6) technique reformating
工艺改变
补充资料：采气工艺(见天然气开采工艺)
采气工艺(见天然气开采工艺)
gas production technology
，一‘J\匕乙吕天然气开采工艺pro以uetionteehnology)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条