说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 动热稳定
1)  power and thermal stability
动热稳定
2)  dynamical thermal stability test
动热稳定试验
1.
When donig the dynamical thermal stability test of GW4-126 series grounding switch, the type of clap-close grounding switch is hard to pass the test, but using the rise and fall structure switch can pass successfully the test, the main reason is caused by the direction of the electrokinetic force, so solves the problem by changing the current flow direction of contact finger.
GW4-126系列接地刀闸在做型式试验中的动热稳定试验时,拍合式接地开关一般很难通过,采用升降式结构则能较顺利通过试验。
3)  adiabatic steady flow
绝热稳定流动
1.
The energy equation for onedimension adiabatic steady flowing of ideal fluid is acquired in two ways.
对理想流体一维绝热稳定流动作了讨论。
2.
The energy formula of adiabatic steady flowing of fluid in the varying cross - section horizontal tube is acquired with the help of the closed thermodynamic system, on the basis of which, the author discusses the influence of the reversibility and the different nature between the fluids on the fluid parameters.
利用闭系能量方程,推出了变截面水平管中流体绝热稳定流动的能量方程。
4)  thermal stabilization kinetics
热稳定动力学
5)  peak/short-time withstand current test
动/热稳定试验
6)  Stability of flow and heat transfer
流动传热稳定性
补充资料:动/热稳定试验
      检验开关的主回路和接地回路(在适用的地方)承载短路电流能力的试验。其中,动稳定试验又称峰值耐受电流试验,热稳定试验又称短时耐受电流试验。
  
  机械式开关在闭合位置所能耐受短路电流的能力可用额定峰值耐受电流或额定动稳定电流Ir(短路电流第一个大半波的电流峰值)、额定短时耐受电流或额定热稳定电流 I(有效值)以及额定短路持续时间或额定热稳定时间t3个参数来表示。
  
  动/热稳定试验可在任意温度、任意适当电压下进行,频率应为受试产品的额定频率,其偏差为±10%。
  
  动/热稳定试验通常联合进行,如因试验设备限制也可以分开进行。试验时,其I2t和动稳定电流峰值Ir不得低于规定值。且与规定值的差为:I2t不得超过10%;Ir值不得超过5%。
  
  试品在承受动稳定电流和热稳定电流的作用后,不得有下列情况之一,否则试品的动/热稳定性能为不合格:①影响试品正常工作的任何机械损伤和局部绝缘损伤而引起的绝缘性能降低;②试品出现自动分闸及各种联锁失灵等;③触头出现熔焊或有影响工作的烧伤;④配人力操动机构的试品用人力合分各3次,配电动操动机构的产品用规定的最低电(气、液)压合分各 3次中出现拒分、拒合;⑤试品的机械特性超过技术条件规定范围。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条