说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> IC数据采集卡
1)  IC data collection card
IC数据采集卡
2)  IC data
IC卡数据
1.
This paper puts forward three basic problems (OD Matrix,Origin primary tend towards and key OD pair )of calculating dynamic OD on the basis of the subway IC data, and makes a theoretical analysis at this point.
提出了基于地铁IC卡数据计算动态OD(起点—终点)的三个基本问题:OD矩阵、O点主流向和关键OD对。
3)  Data acquisition card
数据采集卡
1.
Development of data acquisition card based on PCI interface and CPLD technology;
基于PCI接口和CPLD技术的数据采集卡的设计
2.
The development of an industrial data acquisition card based on the PIC microcontroller;
基于PIC单片机的工业数据采集卡的研究与设计
3.
Design of program for data acquisition card based on VC++;
基于VC++的数据采集卡的程序设计
4)  data acquisition board
数据采集卡
1.
Data acquisition board sampling uncertainty evaluation based on monte carlo method;
数据采集卡采样不确定度的蒙特卡罗评定
2.
By using ADVANTECH PCI-1716L data acquisition board and adopting Visual C++ 6.
报道应用研华PCI-1716L数据采集卡,在Visual C++6。
3.
The whole process of designing nuclear spectrometry data acquisition systemwas particularizedwith LabVIEW and data acquisition board,based on virtual instrument technology.
阐述了基于虚拟仪器的采用LabVIEW和通用数据采集卡开发核能谱数据采集系统的全过程。
5)  DAQ
数据采集卡
1.
Development of drive-programme of DAQ of Non-NI Company in LabVIEW;
在LabVIEW中非NI公司数据采集卡驱动程序的开发
2.
THE MEASURES TO MAKE DRIVE-PROGRAMME OF DAQ IN LabVIEW;
在LabVIEW中编写数据采集卡驱动程序不同方法的比较
3.
A logic analyzer based on NI USB-6009 DAQ,PC,and LabVIEW 8 was constructed.
以NI USB-6009数据采集卡、PC机及LabVIEW8为基础构建了逻辑分析仪。
6)  DAQ card
数据采集卡
1.
The design of DLL for the domestic DAQ card in Lab VIEW;
LabVIEW下国产数据采集卡DLL的设计
2.
Signals from sensors were transmitted to PCI6024E DAQ card and PC by SCXI,Where they were filtered,amplified,and linearized.
本文介绍了一个利用虚拟仪器技术,采用NI-PCI6024E数据采集卡、信号调理模块及PC机构成的柴油发动机测功系统。
3.
A plane wheel speed simulator is developed based on LabVIEW and DAQ card for plane’s experiments on the ground.
针对飞机的地面模拟试验,基于LabVIEW和数据采集卡,开发了飞机机轮转速模拟装置。
补充资料:CT数据采集系统


CT数据采集系统


  CT设备的元件之一。CT设备的扫描-探测环节中的主要组成部分。位于机架内,与X线管相对。在电子束CT扫描机(eletron beam scanner)内则位于机架(gantry)顶部,与钨靶环相对。主要功能是在主计算机控制下,接收由探测器输出的模拟电信号,并使其经过模/数(A/D)转换成为数字化的投影信息,即原始数据(raw data),输给阵列处理器(AP)进行处理。数据采集系统的主要部件是模/数转换器。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条