说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 自适应 RLS
1)  adaptive RLS
自适应 RLS
1.
this paper raises an arithmetic base on adaptive RLS.
对环境的依赖性较强,文中针对这一问题提出基于自适应 RLS 滤波的处理算法。
2)  RLS-like adaptive algorithm
类RLS自适应算法
1.
New RLS-like adaptive algorithm under alpha-stable noise conditions;
Alpha稳定分布噪声环境下新的类RLS自适应算法
3)  adaptive RLS algorithm
自适应RLS算法
1.
The coefficients of the FIR transversal filter was identified by using adaptive RLS algorithm while the output signal of the vibration pick-up was input into the FIR transversal filter.
该方法是将拾振器的输出信号作为FIR横向滤波器的输入,用自适应RLS算法对FIR横向滤波器系数进行辨识而最终获得可以恢复拾振器原始输入信号的反卷积滤波器。
4)  RLS adaptive filter
RLS自适应滤波器
1.
The RLS adaptive filter is used to control the DC-side voltage of the active power filter.
RLS自适应滤波器用于有源滤波器直流端电容电压的控制 ,克服了用LMS自适应滤波器收敛速度慢和稳态误差较大的缺点 ,同时对直流端电容电压的控制完全摒弃了传统的PI积分控制 ,解决了控制参数难以调节及对电路中其他参数的变化非常敏感的问题。
5)  RLS adaptive filter
RLS自适应滤波
1.
The clutter is predicted exactly and subtracted from the input signal by RLS adaptive filter,leaving components of the target signal in the residual noise.
通过RLS自适应滤波器,背景杂波分量被准确地预测并从输入信号中去除,从而只剩下目标信号与残留噪声。
2.
Taking into account channel characteristics of high-speed mobile communication and using an RLS adaptive filter capable of tracking time variations of input statistics under non-stationary conditions,the paper presents an iterative joint channel-estimation and symbol-detection algorithm based on RLS adaptive predictor.
在现有的OFDM系统联合迭代信道估计与符号检测算法的基础上,针对高速移动通信信道,利用RLS自适应滤波器在非平稳环境下有效跟踪输入统计量随时间变化的能力,提出了一类基于对迭代初始值进行RLS自适应预测的迭代信道估计算法。
6)  RLS adaptive algorithm
RLS自适应算法
1.
This paper has introduced the normal equalizer structure and adaptive algorithm at first,then pointed out that the decision feedback equalizer based on RLS adaptive algorithm is capable of attaining the faster convergence speed and having the better equilibrium effect,which has been proved by Matlab simulation.
首先介绍常见均衡器的结构和自适应算法,然后指出基于RLS自适应算法的判决反馈均衡器可以有较快的收敛速度,同时有较好的均衡效果,并通过Matlab仿真证明。
补充资料:自适应自整定调节
分子式:
CAS号:

性质:在调节系统中,对象的动态特性往往是变化的,如果变化不大或调节的质量要求不高时,可以采用固定规律的调节器,假若变化大,质量要求又高时,需要选择可变规律调节器。调节器参数的改变是直接按照对象特性的变化进行的,叫作自适应调节。对象的识别和调节器的规律的计算都用一个计算装置进行,就叫自适应自整定调节,或简称自整定调节。 

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条