说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 啮合冲击
1)  meshing impact
啮合冲击
1.
By means of researching the meshing impact in the engagement of standard chain respectively with the spur toothed sprocket and the involute toothed sprocket,it has been discovered through analysis that by adopting the involute tooth for the sprocket could reduce the normal impact velocity in the engaging instant of chain and s.
通过研究标准链条分别与直齿链轮和渐开线齿链轮啮合的啮合冲击,分析发现在链轮上采用渐开线齿能减小链条与链轮啮合瞬间的法向冲击速度,进而降低链条与链轮的啮入冲击。
2)  mesh impact
啮合冲击
1.
Owing to the modified error in principle, the manufacturing error and the variation of the load,there still exists the mesh impact in the transmission of modified spur gear.
由于存在修形原理误差、齿轮加工误差以及载荷工况的变化 ,渐开线修形齿轮在使用中仍会有啮合冲击现象。
3)  meshing impact
啮入冲击
1.
On the basis of meshing impact dynamics model in gear transmission established in document [1], and by means of theoretical analysis and compiling corresponding analytical program, the impact force of meshing and the variation status of impact speed in the transmission of involute spur gears were calculated.
在文献[1]所建立的齿轮传动啮合冲击动力学模型的基础上,通过理论分析并编制相应的分析程序,计算了渐开线直齿轮传动中啮入冲击力、冲击速度的变化情况,分析了传动比、模数、载荷等对齿轮传动中冲击力的影响情况。
2.
The characteristics of meshing impact is improved by using meshing analysis procedure in FORTRAN language so that such gears will have low-noise performance.
使用逐步逼近法求得超前啮合角,并用FORTRAN语言设计的啮入冲击分析计算程序,确定了改善啮入冲击准则,实现低噪声双圆弧齿轮传动。
3.
It is found that the chain/sprocket meshing impact is reduced and the transverse vibration of chain is decreased by applying the new sprocket.
结果表明采用修形链轮有利于减小链传动过程中的啮入冲击和多边形效应,因而能够有效减小链传动过程中的振动和噪声。
4)  recess shock
啮出冲击
5)  mesh impulsive force
啮合冲力
6)  surge closing
冲击合闸
1.
This article analyzed and studied the GCB(generator circuit-breaker) abnormal crust discharge phenomena,from its casing to support,during the course of surge closing of Three Gorges power plant transformers connected with GCB,and put forward the improvement scheme.
对三峡电厂连接发电机断路器(GCB)主变进行冲击合闸过程中,出现的GCB外壳对支架异常放电现象进行了分析研究,并提出了改进方案。
补充资料:标准操作冲击电压波形(见冲击电压发生器)


标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform

  b .oozhun CooZuo ChongJld,onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条