1) best ventilation velocity
最佳送风速度
1.
Simulates and proves the feasibility of this method with a CFD software, obtaining the best ventilation velocity for this case.
提出了对着火区间隧道两端送新风、利用地铁区间隧道间的联络通道向相邻区间隧道排烟的方法,利用CFD软件模拟并验证了该方法的可行性,得出了该情况下的最佳送风速度。
2) the optimum velocity in conveying
最佳传送速度
1.
Transmitting heat,in the ylindering desiccation,with the result in the possibility of attainment of the maximum of evaporation and the attainment of the optimum velocity in conveying.
研究了滚筒式干燥工艺中水分蒸发和热量传递的规律 ,导出了能获得最大蒸发量的最佳传送速度。
3) optimum speed
最佳速度
1.
To seek an effective method for computing the vehicle s optimum speed in tunnel,an optimum speed fuzzy algorithm with two layers fuzzy decision-making structure was present,its algorithm design and simulation were carried out.
为寻求计算公路隧道内车辆行驶最佳速度的有效方法,将车速、流量、车流密度、能见度、CO浓度、风速、路面状态、时段、工作日、节假日10个影响指标归结为交通状况、环境状况和交通需求3类因素,给出了具有2层模糊决策结构的最佳速度模糊逻辑算法,并进行了算法设计和仿真。
4) optimum velocity
最佳速度
1.
Two equations of classical V belt drives limit velocity( υ lim ) and optimum velocity ( υ opt ) are deduced on the ground of V belt power ratings calculating formula.
根据单根Ｖ带额定功率的计算公式，推导出求解普通Ｖ带传动极限速度υｌｉｍ和最佳速度υｏｐｔ的两个方程，并提供了计算实例。
2.
The formulae of the maximum and optimum velocity of synchronous belt drive are deduced on the basis of the trapezoidal toothed synchronous belt,and then the maximum and optimum velocity of seven types of the trapezoidal toothed synchronous belt are got when the belt width is the width of belt to be rated and KZ is 1.
根据梯形齿同步带传动额定功率计算公式,推导出同步带传动的极限速度和最佳速度计算公式;求出了7种梯形齿同步带带宽为基准宽度、啮合齿数系数为1时的极限速度和最佳速度。
5) air supply velocity
送风速度
1.
Numerical simulation of air supply velocity on air conditioning effects;
送风速度对空调效果影响的数值研究
2.
Experimental result shows better use effect can be reached by means of setting reasonable air supply direction and air supply velocity.
实验研究结果表明,送风方向和送风速度挡的合理设置能使空调器达到良好的使用效果,柜式空调机组合工作时,两台空调机的相对位置、导风板的旋转角和出口风速对室内平均温度的影响较大。
3.
Based on the theory and experiment research of the characteristic of the refrigerated vertical open display cabinets, the method of reasonably select the main structural parameters including air supply velocity,evaporator structure and defrost cycle etc were discussed.
在理论和实验研究立式敞开式制冷陈列柜工作特性的基础上 ,讨论了合理选择陈列柜送风速度、蒸发器结构和融霜周期等结构参数的途
6) supply air velocity
送风速度
1.
Furthermore,based on the measurement at a gymnasium,the variation relationships between the vertical temperature gradient and supply air velocity were obtained.
本文首先介绍了蒸发冷却与置换通风复合空调系统,对复合空调系统的设计过程进行了分析,并给出了完整的设计方法;然后通过对某体育馆的工程测试,得出垂直温度梯度随送风速度的变化关系;最后结合目前中国国情,给出了系统送风速度推荐范围,为设计人员的初步设计计算提供了参考依据。
2.
Analyses the influence of supply air velocity on thermal comfort by experiments.
实验研究了低速和高速两种送风速度对工作区域热舒适性的影响 ,认为在不超过舒适性要求的前提下适当增大送风速度可以提高舒适
3.
Investigates the influence of supply air velocity and heat release rate on air distribution in working area.
在试验研究中考察了送风速度和热源发热量对工作区气流组织的影响。
补充资料：多通道电子风速计(见转杯式风速表)
多通道电子风速计(见转杯式风速表)
爹豁笔戮翁ng’粗转杯式风速表。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条