说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 循环变频器
1)  cycloconverter [,saikləukən'və:tə]
循环变频器
1.
The study of single-chip microprocessor controlled three-phase cycloconverters;
微机控制的三相循环变频器的研究
2.
To solve the problem of limited output-frequency in cycloconverter, a high voltage AC-AC converter topology based on phase shift transformer is presented.
为了解决无环流循环变频器输出频率受限的问题,本文提出了基于变压器移相级联的高压交交变频拓扑。
2)  variable pressure frequency control
变压差循环变频
1.
Three kinds of frequency control techniques were analyzed,including fixed pressure frequency control,constant pressure frequency control and variable pressure frequency control.
针对目前供暖循环水泵电功耗较高情况,提出了利用变频调速技术调节循环泵流量的技术措施,分别就定压循环变频、恒压差循环变频、变压差循环变频3种控制方式进行了阐述,并通过实验数据说明了变压差循环变频控制方式的优越性。
3)  cycloconverters
循环变流器
1.
Based on the mathematical model of the doublyfed induction generator and cycloconverters, the stator fieldorient vector control strategy for variablespeed constantfrequency (VSCF) operation was investigated.
分析了双馈电机的运行特性和能量转换特性,以及它在可再生能源发电领域的良好应用前景;在双馈电机和循环变流器数学模型分析的基础上研究了变速恒频(VSCF)运行的矢量控制和磁场定向控制策略,并给出了矢量控制模型,证明了可以通过控制转子电流,实现系统的变速恒频运行和系统输出有功功率、无功功率的独立解藕控制。
4)  variable-firing-rate and double cyclic
双循环变射频
1.
Combined with the 10th five -year key advanced research project of national defense "Firing technology for rifles with variable-firing-rate and double cyclic systems", the impacting dynamic stresses of this kind of rifle s three key elements(breech mechanism, receiver, firing pin) are analysed and studied in this paper.
本文结合“十五”国家重点预研项目一“步枪双循环变射频发射技术研究”,对变射频步枪的三个关重件(闭锁机构、机匣、击针)在撞击条件下的动态应力进行了分析研究。
5)  frequency regulation of circulating pumps
循环泵变频调节
6)  constant pressure frequency control
恒压差循环变频
1.
Three kinds of frequency control techniques were analyzed,including fixed pressure frequency control,constant pressure frequency control and variable pressure frequency control.
针对目前供暖循环水泵电功耗较高情况,提出了利用变频调速技术调节循环泵流量的技术措施,分别就定压循环变频、恒压差循环变频、变压差循环变频3种控制方式进行了阐述,并通过实验数据说明了变压差循环变频控制方式的优越性。
补充资料:AB变频器在中嘉污水处理厂自动控制系统工程的应用
中嘉无污水处理厂的总处理量是30万吨/天,共分三期兴建,第一期工程处理量为10万吨/天。根据中山市环保局的进水及出水水质要求,该厂采用了先进的氧化沟工艺来达到去除有机物及脱磷脱氧的要求。系统的主要处理工艺流程分为预处理、氧化沟、终沉池和污泥脱水四个部分。采用基于PLC 5 控制器成本低廉的远程通信和控制系统;保证污水处理过程的质量,使得出水水质符合规定的标准;应用先进的PID算法和闭环控制策略以维持化学药品的最佳平衡和最大限度地降低成本高昂的中和药品用量;变频器和智能马达控制器不仅避免电机启动时对电网的冲击,而且起到均衡节能、起停控制和速度调节的作用;友好的用户界面(MMI)和完善的报表输出系统使得管理人员可以很方便地控制、监测系统和排除系统故障,并能及时地得到系统处理过程中的数据,掌握系统的运行趋势。
控制系统所使用的主要软件、硬件设备如下:
PLC A-B PLC 5/30 
现场图形终端 A-B PanelView 1400E 
变频器 A-B 1336 PLUS 
马达软启动器 A-B SMC PLUS 
上位计算机 DELL PII350 
界面平台软件 RSView32 
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条