说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 编码器优化
1)  encoder optimization
编码器优化
2)  codec optimization
编解码器优化
3)  optimization encoding
优化编码
1.
The optimization encoding is to find out a good enough sequence of the messages in a packet to reduce the numher ofidle codes as well as possible,and improve the utilization ratio of communication channel.
优化编码就是寻找一个较优的信息排列顺序,尽量减少一个信息包中的空闲码,以提高通信信道的利用率。
4)  Priority encoder
优先编码器
1.
Logic design of priority encoder by restraining redundancy;
抑制冗余优先编码器的逻辑设计
2.
Taking the expanding of two three-bit priority encoders into one four-bit priority encoder for example and based on the traditional designing method of combinational logic circuit, the expanding functions of priority encoder are realized through the rigorous logical derivation, full use of constraint conditions and various means of logical simplification.
以 2片 3位优先编码器 (T4 14 8)扩展为 4位为例 ,依据组合电路的传统设计方法 ,通过严密的逻辑推导 ,充分利用约束条件 ,应用逻辑简化的各种手段 ,来实现优先编码器的功能扩展 ,同时给出了 4片 3位优先编码器扩展为 5位优先编码器的设计方法。
3.
The article has corrected the mistakes in an example and provided a correct method on how to produce the priority encoder of circuit 32-5 by T4148.
更正了教材中一道例题的错误,给出了用T4148实现32线—5线优先编码器的正确方法。
5)  Optimized ADPCM
优化 ADPCM 编码
6)  code optimization
编码最优化
补充资料:编码器


编码器
encoder

  b旧nmoq,编码器(e ncoder)能将每一根输人线上的信号转换成输出端上的一个对应代码,即实现输人信号编码功能的组合逻挥电路。它广泛用于逻辑电路中。 图示是一个8线一3线编码器的逻辑图,其中I。~I:是八个输人端,YZ、Yl、Y。是三个输出端。当在输人端加上逻辑l信号时,便在YZ、Y、、Y。给出一个对应的三位二进制代码。输人信号与输出代码的省昔阵矛10一卜一h8线一3线编码器的逻辑图对应关系如表1所示。衰1圈中电路的功能裹┌───────────┬────┐│101一12 13 10 101‘17 │YZ Yz Yo│├───────────┼────┤│1 0 0 0 0 0 00 │0 00 │├───────────┼────┤│0 1 0 0 0 0 00 │0 01 │├───────────┼────┤│0 0 1 0 0 0 00 │0 10 │├───────────┼────┤│0 0 0 1 0 0 00 │0 11 │├───────────┼────┤│0 0 0 0 1 0 00 │1 00 │├───────────┼────┤│0 0 0 0 0 1 00 │1 01 │├───────────┼────┤│0 0 0 0 0 0 10 │1 10 │├───────────┼────┤│0 0 0 0 0 0 01 │1 11 │└───────────┴────┘ 在图示编码电路中,任何时候只允许有一个输人信号是l,否则电路不能正常工作。为克服这种局限性,便产生了优先编码器(priority eneoder)。设计优先编码器电路时,预先把所有的输人信号按优先权的高、低排队,当两个以上输人信号同时为1时,只对其中优先权最高的一个进行编码。表2是8线一3线优先编码器功能表,表中的“x”表示既可以是逻辑。,也可以是逻辑l。从表2中不难看出,输人信号I,的优先权最高,I。的优先权最低。例如当17~l时,无论I。~1。当中还有多少个是1,电路只对卜进行编码,使输人为Y:Y IYo=111。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条