1) single and double heads
单双点
1.
Vibrofloatation compacting was done in different spacing with single and double heads, and the technical data were analyzed,some skill parameters of practical value will provides basis for guiding further construction in large area.
此次实验采用了三种不同型号的振冲器,分不同间距进行了单双点的振冲加固,通过对所得技术数据的分析,得到了一些有价值的技术参数,为指导后面的大面积施工提供了依据。
2) single/double track
单(双)靶点
3) single/double point of contact
单、双触点
4) double-nodes element
双节点单元
1.
How to simulate the geometrical figure of dam cracks with double-nodes element was studied firstly, then contact method was used for the simulation of physical characters of the dam cracks.
探讨了如何利用双节点单元实现对混凝土大坝裂缝的长、宽、高等几何形态进行模拟;采用接触算法实现了对带缝大坝裂缝的物理特性模拟;结合实例,研究了此方法在裂缝的成因分析、影响因素以及预测裂缝发展等方面的应用。
5) single cell with two focuses
单池双焦点
1.
This paper reports on the fidelity of Stimulated Brillouin Scattering of single cell with one focus (SCOF) and single cell with two focuses (SCTF).
报道了单池单焦点及单池双焦点两种情况下的受激布里渊散射相位共轭度。
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条