1) wear resistant particles
耐磨粒子
1.
The effects of the content of wear resistant particles and activated sintering agents on the mechanical and friction and wear properties of copper alloyed based dynamic seal materials have been studied,moreover, microstructure of the materials was observed.
研究了耐磨粒子和活化烧结剂的含量对其机械性能和摩擦磨损性能的影响 ,并且观察了其显微组织。
2.
By adding vanadium and niobium into ordinary high Ni-Cr cast iron and tempering treatment, there were small wear resistant particles crystallizing out and distributing uniformly and dispersedly in the matrix; the graphite in both the outer layer and core area of the roll became smaller and more rounded; carbides distribution in outer layer became more uniformly and dispersedly.
通过在普通高Ni-Cr铸铁中加入元素V和Nb以及进行回火处理,在基体中结晶出均匀弥散分布的细小耐磨粒子,使轧辊外层及芯部的石墨变得细小圆整,外层碳化物均匀分散,辊身表面硬度﹑硬度落差、辊颈抗拉强度等力学性能指标均满足轧辊的使用要求。
2) service weight stockings
耐磨袜子
4) Wearing particle
磨屑粒子
5) run hard grind
难磨粒子
6) wear-resistant
耐磨
1.
Application of wear-resistant and lubricating coating for wood cutting tools;
润滑耐磨功能涂料在木工刀具上的应用
2.
The wear-resistant material with best composition and overlay welding process were successfully developed,and the productiviting and the economic benefit were obviously improved.
通过对碎煤齿环的失效分析 ,找出了影响齿环寿命的因素及薄弱环节 ,并研制成功了最优成分的耐磨材料和堆焊工艺 ,显著提高了生产率和企业的经济效
补充资料：初级粒子和原级粒子
分子式：
CAS号：
性质：又称初级粒子和原级粒子。利用各种化学反应方法得到的最初粒子(晶粒)。一次粒子的大小约为0.005～1μm，比筛分的极限小得多，在介质中有相当高的稳定性。
CAS号：
性质：又称初级粒子和原级粒子。利用各种化学反应方法得到的最初粒子(晶粒)。一次粒子的大小约为0.005～1μm，比筛分的极限小得多，在介质中有相当高的稳定性。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条