说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 偏心检测
1)  balance detecting
偏心检测
1.
The application of the MCU in the balance detecting of the cylinder washing machine;
单片机在洗衣机偏心检测中的应用
2)  eccentricity detector
偏心度检测器
3)  elliptical-polarization examination
椭偏检测
4)  unbiased detection
无偏检测
5)  polarization detection
偏振检测
1.
This paper described a polarization detection method to compress the lager dynamic range of laser returned signals in airborne laser bathymetry system.
采用偏振检测方法 ,对机载激光测深实验系统接收到的大动态范围的水下目标反射的激光回波信号的压缩进行了实验研究。
6)  color cast detection
偏色检测
1.
A color cast detection method based on equivalent circle is applied,which overcomes the limit of traditional methods of detecting image color cast.
采用一种基于等效圆的偏色检测方法,克服了传统方法在图像偏色检测中的局限性。
补充资料:在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.

1)连接PA,PB. A(-100,0,0) B(100,0,0)



图1



在当前坐标下:


2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;


3)连接CD;


4)以CD为直径画圆;


5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;


6)过O作CD的垂线,交圆于E,F;



图2



7)用三点UCS命令,取三点为:O,P,C;


8)过点O作PO的垂线GO,交PC于G;



图3



9)再次用三点UCS命令,取三点为O,F,G;


10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;



图4



11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.


12)删除辅助线条.



图5

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条