1) stress coining
应力压印
1.
It is discussed what raised the using life in cold working, without changing structure masurement and increasing weight, throngh doing pin stress coining ,plastic deformation ,changing stress in hold`s high stress region, reducing hold stress peak value in the reversal stretch loading.
主要分析了在MD90飞机尾段装配过程中的新工艺———销棒压印工艺和要求,以及在有无衬套挤压情况下的使用寿命,论述了通过冷加工方法,在不改变结构件尺寸和不增加重量的前提下,在高应力区对孔壁进行挤胀销棒应力压印,使孔周围材料产生塑性变形,改变应力,并在反复拉伸载荷作用下降低孔边应力峰值,从而提高结构件疲劳寿命。
2) force of impression
打印压力;压印力
3) bar expansion stressing
挤胀销棒应力压印
1.
It is to introduce the bar expansion stressing technique for holes.
本文介绍了孔的挤胀销棒应力压印工艺，进行了压印之后孔周围的残余应力和压印前后孔的疲劳寿命计算，并通过计算结果说明了挤胀销棒应力压印对结构疲劳寿命的影响。
4) printing pressure
印刷压力
1.
Then we calculate the maximum printing pressure,the printing pressure of random point and the overall printing pressure by the compress of cylinder dressing.
以胶印机印刷滚筒为例,从油墨附着和印刷机精度的角度分析确定了印刷滚筒包衬的压缩变形量和滚筒挠度的计算方法,然后通过压缩变形量计算横截面上的最大印刷压力、任意点印刷压力和总印刷压力,以便在印刷设计和使用中控制最佳参数。
2.
After an analysis of relevant factors in printing pressure,the author puts forward printing pressures to meet the dot requirements of offset printing when using the diverse offset blankets.
在分析影响印刷压力相关因素的基础上,为保证印刷网点的基本要求,归纳出不同种类橡皮布的印刷压力值。
3.
In addition,the addition and/or reduction of the liner and dimension of printing image in width were calculated,and the right method was presented to control the printing pressure of solid plate,which provided a reference for the coteries.
文中对滚筒包衬的增减与印刷图文宽度尺寸的数据关系作了计算,并提出正确控制实地版印刷压力的方法,供同行参考。
5) force of impression
打印压力
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条