1)  frequency response method
频响方法
2)  Frequency response
频响
1.
This paper introduces a design method and circuit of power supply with high voltage and high frequency response for driving capacitive load.
本文介绍了一种可带容性负载的高电压、高频响激励电源的设计方法及相应的实现电路。
2.
To minimize the frequency response errors produced by the tolerance of the electronic devices,an novel method of automatic calibration, RMS and test procedures based on the curve fit is described to improve the precision in experiments.
为解决由电子元器件本身误差造成的增益不准确以及探头反馈电阻的分布电容造成的频响不准确等问题,文章提出了一种由计算机控制膜片钳放大器的自动校准方案;该方案采用线性拟合、有效值法、最小二乘拟合法和迭代法等算法,通过计算机和数据采集卡对膜片钳放大器进行数字控制和检测,从而实现自动校准;实验结果证明,校准后的参数能真实表现元器件的特性,从而保证实验数据的正确性,使放大器精度得到了提高,频响的正确性也得到了保证。
3.
For the steel pressure bar system at 8 mm diameter,the frequency response is about 115 kHZ and the measurable lower limit is about 3.
为测量爆炸容器壁面反射压力,设计了一种压杆测压系统,对应力波在压杆中的传播进行了数值模拟,分析了压杆测压系统的频响、可测量下限和有效测量时间。
3)  frequency response function
频响函数
1.
Rapid Analysis on Chatter Stability Lobes for High Speed Milling Based on Frequency Response Function;
基于频响函数的高速铣削颤振稳定域快速分析与研究
2.
Identification of added mass according to frequency response function test data;
基于实测频响函数水下航行器附加质量识别方法研究
3.
A method for pile quantitative analysis with frequency response function;
基桩质量定量分析的频响函数法
4)  Frequency Response Function(FRF)
频响函数
1.
This paper derives the equations for sensitivity analysis of shape and amplitude correlation coefficient in frequency response function(FRF),and sets up a structure finite element model for torpedo model by introducing test and the FRF correlation coefficients into the finite element model.
引入试验和有限元模型的频响函数形状和幅值相关系数,推导了频响函数相关系数的灵敏度分析方程,建立了鱼雷模型的结构有限元模型,利用少量试验数据,对初始有限元模型的壳体厚度、弹性模量等参数进行修正,修正后的频响函数相关系数明显提高。
2.
A combined method for structural damage identification based on frequency response function(FRF)and genetic algorithm(GA)was presented.
提出一种基于频响函数和遗传算法的结构损伤识别方法。
5)  amplitude-frequency response
幅频响应
1.
Experiments demonstrate that the system has good amplitude-frequency response to the nano level vibration in the tunneling state.
实验表明,实验系统在隧道状态下对纳米级振动有很好的幅频响应。
2.
1 times more than 1/ω, the error of amplitude-frequency response is less than 3%.
为分析无源RC积分器的频率响应特性,给出了包含杂散参数的无源RC积分器等效电路,应用PSpice软件进行了模拟计算,指出了RC积分器与RC低通电路幅频响应分析方法的差别,并给出采用20lg(RCωAU)作为波特图纵轴的分析方法。
3.
The amplitude-frequency response characteristics of the acceleration sensor at low temperature are tested, and suggestions are given on the application of the acceleration sensor at low temperature.
对加速度传感器低温幅频响应特性进行了试验,给出了加速度传感器在低温下使用的建议。
6)  Low-Frequency Response
低频响应
参考词条
补充资料:频响范围
   

    从声学的角度来说,声音是以波的形式存在并传播的。而波是振荡的,波的单位是Hz(每秒钟振荡的次数),因此这也就成了声音的一个单位。声波的Hz数值越小,声音就越响,Hz值越大,声音就越小。从人耳的结构而言,理论上最轻听到20000Hz的声音(但在现实生活中几乎很少存在),而一些动物则可以挺高更高Hz数的声音,如狗据称可以听到50000Hz。

    MD机的频率范围在一定程度上指的是产品可以播放的响度范围,目前常见的是20-20,000Hz,但是实际上真的到了最大值或者是最小值,人耳实际上都是无法接受的。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。