1) externally laminated pressed
外装压
1.
According to the construction characteristics of box type motor, this paper introduces the design characteristics and processing of externally laminated pressed construction for this new box type motor in detail, and gets satisfied results by comparison with the performance of traditional motor.
针对方箱式电机的结构特点 ,详细介绍了这种新型方箱式电机的外装压结构的设计特点以及工艺性 ,最后通过与传统式结构电机的性能比较 ,取得了令人满意的结果 ,具有推广应用价值。
2) external supercharger
外增压器;外装增压器
3) high pressure spraying equipment
高压外喷雾装置
4) outdoor high voltage switching device
户外高压配电装置
5) outer pressure
外压
1.
Viscous inner and outer pressure forming of 1Cr18Ni9Ti specimen with thin-wall curved surface;
1Cr18Ni9Ti薄壁曲面件粘性介质内、外压力成形
2.
In this paper, an alternative method employing inner and outer pressure with viscous media is proposed to form this kind of workpieces as a whole.
本文提出粘性介质内、外压力成形方法,可以直接整体成形薄壁曲面零件,不需要成形后的组合焊接,并针对直径变化比达35%的1Cr18Ni9Ti薄壁曲面零件进行了内、外压力成形实验和有限元分析,给出了变形过程粘性介质和坯料的流动规律和缺陷的预测分析,研究结果表明,薄壁曲面零件内、外压力成形是可行的。
6) external pressure
外压
1.
This article described the basic process for design a external pressure vessel(including shell,elliptical head and cone) by the way in the ASME Ⅷ Div.
通过一个实例介绍了按ASME第Ⅷ卷第一分册中的规定———外压作用下带锥壳设备的设计过程,并给出了锥壳与筒体连接处截面组合有效惯性矩的计算方法。
2.
Instability of bellows under external pressure with tensile displacement was researched by bellows instability tests and nonlinear finite element analysis.
对波纹管在拉伸条件下的外压稳定性进行了试验研究和非线性有限元分析 ,结果表明拉伸位移对波纹管的外压稳定性有不利影响 ,失稳是由于某一波纹局部区域的大量塑性变形而产生的。
补充资料：压装
1.谓充实行装。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条