1)  adjustment method
调幅法
2)  the moment-adjusting method
弯矩调幅法
1.
The linearity-elasticity method, the moment-adjusting method and the plasticity limit analyzing method for calculating the bending moment of two-way slabs are studied and summed up in this paper, on the basis of which a new quick and precise quadratic regression method for the calculation of parameters for the linearity-elasticity method is put forward.
归纳分析了双向板的三种实用计算方法线弹性分析法、弯矩调幅法以及塑性极限分析法,建立了快捷精确的线弹性法的二次回归参数计算方法。
3)  reverse bending moment adjust method
逆向弯矩调幅法
1.
According to the concept of bending moment adjust method applied in the design of frame beam units,This paper puts forward reverse bending moment adjust method in FRP reinforcing ultimate bearing bending moment of frame beams, which is analyzed by plastic theory.
根据弯矩调幅法在框架梁构件设计中的思想,提出逆向弯矩调幅法用于FRP补强框架梁构件极限抗弯承载力的设计,结合塑性理论的方法,得到该法利用内力重分布的特性,不但提高了框架梁构件的极限抗弯承载能力,而且有效防止超筋梁的出现,满足抗震加固的要求,并且施工方便,为框架梁的加固方案开辟了新思路。
4)  amplitude modulation
调幅
1.
The inductosyn's output signal is an amplitude modulation signal and its amplitude is small.
感应同步器输出的感应信号是调幅信号且幅度很低,为采用幅度细分技术,需对其输出的感应信号无失真的放大。
2.
Based on the nonlinear characteristic of sound filed response of reproducing difference frequency wave,study on the influence of amplitude modulation and the preprocessing of sound signal on acoustic distortion and power consumption.
基于再现差频波声场响应非线性的特点,系统研究了调幅方式、声信号预处理等方面对再现差频波声场响应和功率消耗的影响,分析得到了波形、带宽、调幅系数、频率对失真度之间的关系。
5)  AM
调幅
1.
Dynamic ISAR Imaging of Maneuvering Target Based on Multicomponent AM-LFM Signal Parameter Estimation;
基于调幅-线性调频信号参数估计的机动目标成像方法
2.
After sampling by the sound card,the AM signal is demodulated in the digital domain and the pulse signal is recovered.
利用线性调幅的方法,可以将脉搏信号的频谱移动到声卡所能采集的范围内,通过声卡采集后,在数字域中进行调幅信号的解调,从而恢复脉搏信号;同时还讨论了普通调幅波的一种实现方法及数字调幅波的解调原理。
3.
In the amplitude modulation,in accordance with the strength of signals in the spectrum of different components,it is divided into ordinary AM(amplitude modulation standard AM),with inhibition of bilateral carrier AM(DSB),the carrier single sideband supp.
在幅度调制中,根据已调信号的频谱分量不同,分为普通调幅(标准调幅AM)、抑制载波的双边带调幅(DSB)、抑制载波的单边带调幅(SSB)。
6)  Spinodal Decomposition
调幅分解
1.
The spinodal decomposition in hot-dipped aluminum steel and the wavelengths of spinodal decomposition at initial stages;
钢表面热浸渗铝层组织中的调幅分解及初期波长
2.
Spinodal Decomposition Structures in Diffusion Layer of Aluminized Steel and Its Formation Mechanism;
渗铝钢中的调幅分解及其形成原因
3.
The features of spinodal decomposition beside the interface in 321/Qd370qD explosive welded plate;
321/Qd370qD爆炸焊接调幅分解特征
参考词条
补充资料:调幅
载波振幅按调制信号振幅而变化的调制方式。载波经调幅后成为调幅波。调幅波的最大与最小振幅之差的一半与其和的一半之百分比称为“调幅度”。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。