说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 内接弦线
1)  the inside connecting cord
内接弦线
2)  inner cosine curves
余弦内曲线
1.
The composed parts, principle of work, distribute axis of oil, oil pressure cylinders, pistons, equation of inner cosine curves are ntroduced.
介绍了旋转液压缸径向活塞式油压马达组成部份、工作原理、配油轴、液压缸、余弦内曲线方程。
3)  internal bridge connection
内桥接线
1.
The misoperation of differential protection adopted the number of main transformer winding in the substation with internal bridge connection was analyzed in detail and its corresponding measures were put forward.
详细分析了内桥接线变电站中采用主变压器绕组数差动保护装置造成误操作的弊端,并提出了相应的补救措施;介绍了目前福建省110kV主变压器差动保护使用主要产品的应用特点和选型要求;最后建议采用主变压器绕组数+1的差动保护装置。
2.
Incoming line back-up self-switching equipment is universally applied in 110 kV substation with internal bridge connection for further ensuring the safety,stable operation & improving reliability of system.
110 kV内桥接线变电站普遍采用进线备自投,来进一步保证系统的安全、稳定运行及提高系统供电可靠性。
3.
In the substation of internal bridge connection,the main transformer operates in parallel with another transformer.
内桥接线变电站的主变压器并列运行时,其中一台变压器支路空载合闸或故障时,内桥开关将通过很大的励磁涌流或短路电流。
4)  inner bridge connection
内桥接线
1.
This article introduces some layout schemes of outdoor switchgear with inner bridge connection, and discusses the features of operation, maintenance, land occupation and other respects of each of these schemes.
文章介绍了采用内桥接线的几种配电装置型式 ,论述了其在运行、检修、占地等方面的特点 ,对设计部门及运行单位选择该接线配电装置型式有一定参考价
5)  inner-bridge connection
内桥接线
1.
The paper presents 4 kinds of action logic of bus-bar automatic transfer switch equipment for whole inner-bridge connection.
介绍了完整内桥接线情况下备自投装置的4种动作逻辑。
6)  chord line
弦线
1.
A new method to lay-off the circular curve——the polar coordinate of the chord line;
圆曲线测设新方法——弦线极坐标法
补充资料:星接阻抗和三角接阻抗的变换


星接阻抗和三角接阻抗的变换
transformation between starc-onnected and delta-connected impedances

x ing]一e乙日kongl介e sonJ一00}Iez日伙ongde匕一。一〕huon星接阻抗和三角接阻抗的变换(t ransfor-mation betweenstar一eonneeted and delta-eonneeted imPedanees)接成星形的三个阻抗和接成三角形的三个阻抗互相替代的等效变换。它们之间的关系可用一组变换公式表示。按这组公式,用星接阻抗替换三角接阻抗或者反过来,不会影响稳态下电路其他部分的正弦电压和电流,常用于对称三相电路的分析和计算。 图1为三个阻抗21、Z:、23接成星形(又称丫形)。图2为三个阻抗Z小22。、Zal接成三角形(又称△形)。它们之间的变换公式如下:人23土图1星接阻抗图2三角接阻抗(1)将星形连接变换成三角形连接212一Z:+22+2 122及3一22+za十警(1)、|冬|矛231一23+21+2321(2)将三角形连接变换成星形连接z、-二一典乒兴-) 艺‘2士乙“3十乙31…_2 oqZI,}Z。一下万~一二-二二-汁 乙‘2士乙23十乙3‘1_Z。IZoq}艺q一二二一~二,二二--,-二二-~J 乙12十乙23十艺32夕(2) 当三个星接阻抗相等,即21一Z:一23一z丫、三个三角接阻抗相等即212一223一231一Z△时,变换公式是 Z二一32丫,Z丫一Z△/3
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条