说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 试算
1)  Trial calculation
试算
1.
According to the form of water flow convergence of the deepened-stilling basin,through hydraulic calculation,this paper derives the formula of the depth and length of a deepened-stilling basin,and provides the calculation processing combined with the practical project,because the S and h c1 are a complex latent function and trial calculation are needed.
本文根据挖深式消力池的水流衔接形式,通过水力学计算推导出了挖深式消力池的池深和池长的计算公式,由于消力池池深计算公式中与之间是一复杂的隐函数关系,故需要试算,本文结合具体实例给出了试算的计算过程。
2)  pilot calculation
试算,估算
3)  measuring and calculation
测试计算
1.
Meanwhile, comparison of the heat efficiency obtained with measuring and calculation method was performed.
并通过计算,可以确定焊接电弧的热效率,同时与焊接热源有效利用率的测试计算方法所得到的焊接热效率值进行了比较。
4)  trialcalculated result
试算结果
5)  Trial algorithm
试算法
1.
trial algorithm for computing economical well density is advanced by using the empiri-cal formula which is well used to compute economical well density in oil fields of ShengliPetroleum Administration, and based on former Soviet man M.
胡斯努林等人提出的计算采收率公式,推导出适用于胜利油田合理井网密度的经验公式,并提出了相应的计算机试算法,实现了试算步长的自动更新,克服了以往图解法的繁琐和不准确性。
2.
This article presents a dynamic stock model based on the time value of funds and Added Value Txa, and two kinds of algorithm about this model equivalent algorithm and trial algorithm, which is subdivided in to trial order quantity method and trial order lot method.
提出了考虑资金时间价值与增值税的动态存储模型 ,并给出了两种解法 ,试算法和约算法。
6)  test algorithm
测试算法
1.
In the paper,basic theory and architecture of BST will be introduced detaily,then one optimal test algorithm is presented,at last an applied widely,effective and low cost BST method is introduced.
本文详细介绍了边界扫描技术的基本原理和结构,并提出了一种优化的测试算法,最后介绍了一种可以广泛应用、高效低廉的边界扫描测试方法,实现对芯片级、板级和系统级集成电路进行测试的功能。
2.
The paper studied a segmentation algorithm of PCB network set,put forward a test algorithm based on response from stimulation to the network set,gave the test circuit and(control) flow charts based on the algorithm.
文章研究了印制电路板(PCB)网络点集合分割算法,提出了网络集加激励产生响应的测试算法,给出了基于该算法的测试逻辑电路和控制流程图。
补充资料:试算表(trialbalance)
  定期地加计分类账各账户的借贷方发生及余额的合计数,用以检查借贷方是否平衡暨账户记录有无错误的一种表式。该表通常设有“账户名称”栏和“期初余额”、“本期发生额”、“期末余额”三个金额栏。通过总分类账户本期发生额和余额对照表,除可验算全部总分类账户发生额及期末余额是否平衡外,还可一般地了解该期间经济活动和预算执行的概况;另外,该表提供的数据通过必要的计算和调整,也可作为编制会计报表的重要依据。实际工作中,有时在试算表中只列示账户的期末余额,称为“差额试算表”或“账户余额”试算表,或只列示账户的本期发生额,称为“本期发生额试算表”。

  试算表可在结账前编制,亦可在结账后编制。前者称“结账前试算表”,可以检查结账之前,各账户的记录是否正确无误,为顺利完成结账工作做事先的准备;后者称“差额试算表”,可以检查各账户结账后的余额是否正确,并为编制会计报表提供依据。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条