说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 走字试验装置
1)  multi-functional tester
走字试验装置
1.
The performance,working theory and software of multi-functional tester of single-phase watt-hour meter is introduced.
介绍了单相电能表多功能走字试验装置的性能、工作原理及软件系统构成 ,并根据实际使用情况提出了改进意见 。
2)  test equipment
试验装置
1.
Logical control unit emulational test equipment for locomotive;
机车逻辑控制单元仿真试验装置
2.
On the basis of analyzing typical impact erosion and cavitations erosion test equipment and methods in sandy environments,in view of the special wear patterns in our national hydraulic machinery and hydraulic architecture,a new type of water jet test equipment and method that can be applied to study submerged synergic wear of impact erosion & cavitations erosion was introduced.
实验室泥沙冲蚀与气蚀复合磨损模拟试验结果表明,该试验装置设计合理,可以在较短时间内获得试验数据。
3.
The paper introduces a kind of simulation test equipment of the mash screen.
目前国内外的筛管试验装置主要是对其材料或局部进行试验,难以评价筛管的整体性能,特别不适用于金属棉防砂管(简称优质筛管)。
3)  test device
试验装置
1.
Behavior testing and errors analyzing on an abrasive wear test device;
一种磨料磨损试验装置及其性能测试与误差分析
2.
Design of the test device for the frictional abrasion of the sucker rod centralizer
往复式抽油杆扶正器摩擦磨损试验装置设计
3.
The test device provides the advanced way to the pressure gradient and flow state experiment of Multiphase Flow in well removed liquid and produced gas, conventional gas production in continuous gas-lift simulation experiment, and analysis of lift efficient of continuous gas lif.
完成了球塞气举试验装置的结构和控制系统设计。
4)  testing device
试验装置
1.
A new multifunctional testing device for rock fragmentation;
新型多功能岩石破碎试验装置
2.
The temperature measuring and control system of this testing device consists of ultrared heating device,temperature control room,simulation load,electrical power control board and single chip microcomputer.
研制了适用于对电工电子器件控制器等进行高温环境试验的带载高温环境试验装置 红外加热器、温控房、模拟负载、电源控制柜、单片机构成了该装置的温度检测与控制系统 ,系统的核心由AT89C5 2单片机组成 ,用来完成温度检测与控制、时间控制、报警等功能 。
3.
In this paper,a testing device of torsional vibration damper for tank engine is presented.
本文介绍了用于坦克发动机扭振减振器性能测试的试验装置的特点, 并着重介绍了该试验装置模拟轴系的设计思想和原理及参数确定的依据。
5)  experimental device
试验装置
1.
It has introduced mainly the hardware structure, the control technology, and the experimental way and effect of the gas explosion experimental device in this paper.
主要介绍了煤矿安全技术培训中瓦斯爆炸演示试验装置的硬件结构、控制技术、试验方法和效果,为进一步搞好煤矿安全技术培训质量,推动煤矿安全的健康发展奠定了技术基础。
2.
A flexible experimental device which is proved to be cheaper and more functional is developed for teaching and researching.
介绍了研制的一种性价比高 ,具有开放性、多功能的高柔性数控试验装置 ,为教学和研究开发提供试验设备 。
3.
A special impact experimental device and measurement system for vehicle models landing is established that makes real - time record of impact force ,impact time and impact rate of models carry out.
介绍自行研制的用于模拟航天器着陆的撞击试验装置和测试系统。
6)  tester [英]['testə(r)]  [美]['tɛstɚ]
试验装置
1.
Design of the tester for down-hole oil/gas separator;
井下油气分离器试验装置设计
2.
Development of conditioning and cleaning unit tester;
单元清扫器试验装置的研制
3.
Development and manufacture of tester on the dynamic parameters for diggingmac hine;
挖坑机动态力学参数测试试验装置的研制
补充资料:串联电容补偿装置试验


串联电容补偿装置试验
series capacitor/compensator testing

ehuonl一ond一onrong buehong zhuongzhl sh一yon串联电容补偿装里试验(series eapaeitor/eompensator testing)在制造、安装和运行中采用测试设备鉴定串联电容器、金属氧化物限压器和整套申联电容补偿装1的质量和性能是否符合设计、使用及合同规定要求的试验。试验可分为制造部门试验及现场试验两大部分。 侧造部门试脸又分为型式试验、出厂试验和特殊试验,主要目的是确保串补装置的主要元件及组件质t,满足合同规范的要求,其中包括在规范书中引用的相关标准的规定。特殊试验可包括:电容器和金属暇化物限压器的老化试验,电容器和金属氧化物限压器的成组批量试验,旁路间隙放电特性试验等类似的试验。这些试验都应在合同规范书中有明确的规定。 现场试验其目的是确保整个串补装置按合同规范的要求正确地安装、运行。其中包括现场设备试验、系统试验以及投人运行后定期的预防性试验。 现场设备试验主要包括:旁路断路器及隔离开关试验;平台试验;单个和成组电容器试验:外观检查、密封性试验、电容量及损耗角正切测量、极间及极对外壳耐压试验、极对外壳绝缘电阻测量等(见并联电容器试脸);各组电容容抗及不平衡度测量;旁路间隙高电压试验;金属氧化物限压器组件试验(见进雷器);阻尼元件试脸,电流传感器或电流互感器试脸;信号传递系统的耐压试脸,光纤系统的衰减试脸;继电保护试脸.控制及保护设备;平台对地通讯设备的功能侧试.其他监控及自动记录设备试脸等。 系统试脸主要包括:①加电压和加负荷试验,用以检脸整套补偿装t各部分是否良好;②带负荷投切申联电容器试脸,以检脸补偿效果和金月氧化物限压器、旁路间晾及旁路断路器的动作性能是否符合要求,③投人空载变压器(或并联电杭器)试验,以观察是否出现铁磁谐振以及谐波衰减情况;④短路故障试验,包括被补偿线路申补装t的两侧及相临线路的短路试脸,以校验申补装工保护系统及物电线路继电保护系统动作的正确性,潜供电落自灭能力,在消弧线圈接地系统,还要观察是否发生申联谐振,⑤次同步谐振试验,若汽轮发电机组通过申联电容补偿线路接人系统,观察是否出现次同步谐振(见辛联电容补偿系统中的特珠问越)以及次同步谐振继电保护装工及其他抑制措施运行是否正常;⑥感应电动机起动试验,在装有申补装t的配电网要首先观察是否出现自励磁现象,然后在全负载下进行断电重合试验,检查全线电动机起动是否正常。在实际工程中,系统试验需根据具体情况进行部分项目或全部项目试验,或补充新的试验项目。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条