1) hierarchical service restoration
分层故障恢复
1.
In this paper, an idea of hierarchical service restoration by using substation computer and center computer and a multiple-object optimization algorithm are presented.
本文提出了用子站和主站进行分层故障恢复的思想和一种考虑多目标优化的恢复算法。
2) fault recovery
故障恢复
1.
Case-based reasoning method for fault recovery with expanded similarity space;
扩展相似度空间的案例推理故障恢复方法
2.
Some key techniques including communication among the nodes, load balancing and scheduling, parallel compiling, parallel debugging, fault recovery and parallel programming environment for developing COW and the new advances in these techniques are analyzed in detail in this paper.
对建立实用并行机群所需的机间通信、负载平衡和调度策略、并行编译、并行调试、故障恢复与容错、以及并行程序设计环境等关键技术及其研究开发工作的新进展做了比较详细的分析。
3) fault restoration
故障恢复
1.
A model for fault restoration based on MPLS-DiffServ traffic engineering;
一种基于MPLS-DiffServ流量工程的故障恢复模型
2.
Study on message drop and disorder in MPLS fault restoration;
MPLS故障恢复中报文丢失及失序问题研究
3.
An evaluation method for fault restoration performance of MPLS networks based on m:n policy;
一种基于m:n策略的MPLS网络故障恢复性能评估方法
4) service restoration
故障恢复
1.
Advances of the distribution system service restoration;
配电网故障恢复研究现状与展望
2.
Shipboard power system service restoration based on the chaos genetic algorithm;
基于混沌遗传算法的舰船电力系统故障恢复
3.
A distribution network reconfiguration algorithm based on least weight tree for service restoration after faults;
基于最小生成树理论的配电网故障恢复算法
5) recovery
[英][rɪ'kʌvəri] [美][rɪ'kʌvərɪ]
故障恢复
1.
A Method of MPLS-based Network Recovery;
一种MPLS网络的故障恢复方案
2.
Scheme of MPLS-based Recovery;
一种MPLS的故障恢复方案
3.
A New Method of MPLS-based Network Recovery;
一种新的MPLS网络故障恢复算法
6) failure recovery
故障恢复
1.
A distributed algorithm of failure recovery;
一种分布式故障恢复算法
2.
This paper gives the QoS realization methods with some key technologies such as the architecture ,traffic engineering ,loop control ,failure recovery and precaution and so on, based on the principle of MPLS(multi-protocol label switching) technology.
基于MPLS技术的基本原理,从体系结构、流量工程、环路控制、故障恢复与防止等关键技术出发,对实现QoS的方案展开研究,在实际应用中,通过有限的软硬件升级,实现端到端的QoS保证。
3.
A functional relationship between the relevant parameters of the failure recovery and the productivity of an automatic assembly unit is established.
在建立自动装配单元生产率与故障恢复有关参数的函数关系的基础上，提出了基于装配生产率的最佳故障恢复路径的确定方法，以及故障恢复有关参数敏感性的分析方法，可作为自动装配单元设计和改进的依据。
补充资料：垂向分层理论
垂向分层理论
stratification theory of grains in vertical direction
ehuix旧ng feneeng Iilun垂向分层理论(stratifieation theory of grainsin vertieal direetion)对重选过程中矿粒群在介质中作垂向分层运动机理的阐释。在重选设备内堆置或铺置的动态矿粒群称作床层。借助介质的垂直流动、沿斜面流动或作回转运动使床层松散，是粒群发生分层转移的先决条件。分层是指矿物粒群按密度差形成不同的矿物层;颗粒的粒度以及形状对分层也有重要影响。对于分层的发生机理，曾经有过多种见解，但归纳起来不外两类观点。一类是动力学分层学说，认为分层是按个别颗粒在介质中的运动差异发生的(见自由沉降速度差分层学说、干涉沉降速度差分层学说);另一类是静力学分层学说，认为分层是粒群整体的内在不平衡因素引发的(见悬浮体密度差分层学说、位能分层学说和重介质分层学说)。前一类学说强调了流体动力对颗粒运动的影响，而忽略了颗粒间的静力作用;后一类学说的立论观点则忽视了流体动力对分层的影响，而将床层内颗粒或颗粒群间的静力差异视为分层的决定性因素。 (孙玉波)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条