说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 镉镍电池正极浸渍液
1)  Ni Cd battery anode impregnating solution
镉镍电池正极浸渍液
1.
Cobalt content in Ni Cd battery anode impregnating solution is analyzed using AIR C 2H 2 atomic absorption spectrometry.
简述了运用AIR -C2 H2 原子吸收光谱法进行镉镍电池正极浸渍液中钴含量的测试 ,分析了钴最佳测定条件以及呈良好线性范围的浓度 ,同时对样品消化处理条件、干扰因素进行了综合考虑。
2)  Cd-Ni batteries impregnating solution
镉镍电池浸渍液
3)  positive impregnating solution
正极浸渍液
1.
The application of nitrous oxide-ethyne flamic absorbing spectral method to measure the content of Si in positive impregnating solution of Ni-Cd batteries was studied.
研究与运用一氧化二氮 乙炔火焰原子吸收光谱法进行镉镍电池正极浸渍液中硅含量的测定。
4)  Electrolyte solution of Ni_cd battery
镉镍电池电解液
5)  Ni-Cd battery
镍镉电池
1.
The measurement of iron content in 20 mould nylon felt material of the Ni-Cd battery was studied by air- C_ 2 H_ 2 flame atomic-absorption spectroscopy, and measuring conditions and interfering factors were analyzed.
采用空气-乙炔火焰原子吸收光谱法测定镍镉电池尼龙毡材料中的铁含量,对测定条件和干扰因素进行了综合分析。
2.
In this paper, the structure and principle of the Ni-Cd battery , llsed in modern surveying instruments,ave analysed in detail,anf the favourable factors of In the tnd the methods of invalid detevting and the e-liminating of remembering effeet of the Ni-Cd battery ave disvussed.
对现代测量仪器中的镍镉电池,从结构与原理进行了详细分析,度结合实例提出了存放与使用过程中的有利条件、最后阐述了镍镉电池记忆效应的消除及效检测的方法。
6)  cadmium nickel battery
镉镍电池
1.
Continuous determination of zinc, copper and iron in porcelain insulator plating liquid of cadmium nickel battery was carried out by flame atomic absorption spectrometry.
采用火焰原子吸收光谱法进行镉镍电池陶瓷绝缘子镀液中锌、铜、铁含量的连续测定。
2.
This paper studied the measurement of lithium content in electrolyte solution of Cadmium nickel battery by using the N_2O-C_2H_2 flame atomic-absorption spectroscopy and process synthetically considering measuring conditions and factors.
简述运用N2O-C2H2火焰原子吸收光谱法进行镉镍电池电解液中锂含量的测定,并介绍了锂最佳测定条件及呈良好线性范围的浓度。
补充资料:镉/镍蓄电池
分子式:
CAS号:

性质:又称镍/镉蓄电池。一种碱性蓄电池,以羟基氧化镍为正极活性物质,活性金属镉为负极活性物质,含有或不含少量氢氧化锂的氢氧化钾溶液为电解质。是瑞典人W. Jungner于20世纪初研制成功的。按结构变化分三个发展阶段:(1)20世纪50年代前,电极结构为极板盒式(袋式);(2)50~60年代初电极为烧结式;(3)60年代以后为密封式蓄电池。运行时的电化学反应: 正极      NiOOH+H2O+e-→Ni(OH)2+OH-  负极      Cd+2OH--2e-→Cd(OH)2电池反应  2NiOOH+Cd+2H2O→2Ni(OH)2+Cd(OH)2电池循环寿命长,可达2000~4000次,结构坚固,低温性能和大电流放电性能好,可以制成免维护蓄电池。烧结式电池比功率可达470~800W/kg,最大放电电流可达40C放电率,单体电池以0.2C放电率放电时工作电压约1.2V。缺点是充电效率和能量效率较差,烧结式电池有记忆效应,价格昂贵。广泛应用于引擎起动,动力牵引,照明和空间技术能源系统。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条