说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 底排燃气
1)  burning gas
底排燃气
1.
A secondary expansive principle of the burning gas pressure vary without the external pressure is presented in this paper.
提出了底排燃气压力不随外部压力变化既可改善底部弹射击精度又可提高减阻效果的二次扩张原理 ,建立了底排燃气二次扩张压力的计算模型 ,并通过采用二次扩张原理的新型底排装置与传统底排装置的对比试验 ,验证了新型底排装置结构实现的可行
2)  base bleed burning
底排燃烧
1.
An investigation of wind t unnel tests of base bleed is conducted,in order to research the characteristics of base drag reduction with base bleed burning H2+air and base bleed cold air in subsonic and transonic speeds.
说明在亚、跨声速下采用底排燃烧的方法仍可有效减少弹丸底部阻力增加射程。
3)  base bleed
底部排气
1.
The influence of the key parameters on the drag reduction of the base bleed method is obtained by numerical study.
采用数值模拟试验的方法较为系统地研究了底部排气减阻中气流的排出方式、流量消耗率、排气孔孔径和排气孔的收敛或扩张角等因素对底部阻力的影响 ,并将排气减阻的贡献分解为排气冲量和底部压强两部分进行了分析。
2.
This paper briefly reviews the general situation of investigations of base flow, the characteristics of a series of projectile boattails and the reduction technic in the base drag by using base bleed and external buring.
本文扼要地介绍了底部流动研究现状、新型收缩尾部的特点以及底部排气和外部燃烧等减阻技术。
4)  Bottom exhaust
弹底排气
5)  full firing
排气助燃
1.
Two kinds of representative CC-Repowering (feed water heating repowering, full firing repowering) are study in this paper.
本文针对两种典型的联合循环系统(排气助燃型和给水加热型)进行了研究,给出了这两种联合循环及其在用以增容改造已有的蒸汽轮机电厂时的性能简明示式和典型数据。
6)  exhaust detonation
排气燃炸
补充资料:阿钵底钵喇底提舍那
【阿钵底钵喇底提舍那】
 (术语)A^patti-pratides/ana,忏悔之梵语,新译曰说非。寄归传二曰:“阿钵底者,罪过也。钵喇底提舍那,即对他说也,旧云忏悔。非关说罪。何者?忏摩乃是西音,自当忍义。悔乃东夏之字,追悔为目。悔之与忍回不相干。若的依梵本,诸除罪时,应云至心说罪。”饰宗记八本曰:“旧云忏悔。”
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条