1) cone cylinder
锥-柱结合壳
2) cone-cylinder shell
锥柱结合壳
1.
The model of submarine cone-cylinder shell structure is built.
总结了基于有限元方法的断裂力学J积分理论,利用MARC软件建立了潜艇锥柱结合壳有限元分析模型,计算潜艇典型裂纹承受300 m静水压力和不同炸药重量及距离下的J积分。
3) ring-stiffened cone-toroid-cylinder combination shell
加肋锥-环-柱结合壳
4) ring-stiffened concave cone-toroid-cylinder combined shell
凹型加肋锥-环-柱结合壳
1.
The experiment research on stability of ring-stiffened concave cone-toroid-cylinder combined shell is presented.
文章对凹型加肋锥-环-柱结合壳稳定性进行了模型试验研究,观察到凹环壳段失稳的一个特殊现象。
2.
The experiment research on stability of ring-stiffened concave cone-toroid-cylinder combined shell is presented in this paper.
本文对凹型加肋锥-环-柱结合壳稳定性进行了模型试验研究,观察到凹环壳段失稳的一个特殊现象。
5) protruding-concave ring-stiffened cone-toroid-cylinder combine shell
加肋凸、凹锥-环-柱结合壳
1.
The valuable conclusion about bulkhead arrangement and structural parameter design of protruding-concave ring-stiffened cone-toroid-cylinder combine shell are deduced.
运用分区样条等参元法对舱壁不同布置位置的潜艇加肋凸、凹锥-环-柱结合壳进行强度分析,得出了一些对指导凸、凹型锥-环-柱结合壳结构设计和舱壁布置有实用价值的结论。
6) ring stiffened concave cone-toroid-cylinder combined shell
加肋凹锥-环-柱结合壳
补充资料:柱,锥,台体体积公式
v台体=1/3h(s上+√(s下*s上)+s下)
当s上=s下时:
v柱=s*h
当s上=0时:
v锥=1/3s*h
都可根据台体体积推得."s上"为台体上体面,"s下"为台体下底面,"h"为高.
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条