1) suction valve
注气阀
1.
Principles of water hammer protection on injection water device and suction valve are investigated with an example,and also the method of selection and arrangement .
结合工程实例,探讨了在事故停泵水锤过程中,注气阀、单向注水装置等水锤防护措施的作用机理,且按水锤基本理论选用了布置方法,建立了单向注水装置边界条件数学模型,并对泵站各种工况下的停泵水锤进行了计算和对比分析。
2) air valve
气阀
1.
The analysis of compressor air valve damage mechanism and precautionary measures;
压缩机气阀损坏机理及预防措施分析
2.
Analysis of the influencing factors on the lifetime of the air valve of industrial compressor;
影响工艺用压缩机气阀寿命的因素分析
3.
The optimum design of air valve string in the piston compressor;
活塞式压缩机气阀弹簧的优化设计
3) Gas valve
气阀
1.
Fault diagnosis for gas valve based on negative selection algorithm;
基于反面选择算法的气阀故障诊断
2.
Information fusion method of fault diagnosis for gas valves of reciprocating compressors;
往复压缩机气阀故障诊断的信息融合方法研究
3.
Time-Frequency Analysis Method of the Fault Diagnosis ofthe Gas Valves of Type 2D12 Reciprocating Compressors;
2D12型往复式压缩机气阀故障诊断的时频分析方法
4) valve
[英][vælv] [美][vælv]
气阀
1.
Failure analysis of low pressure gas Valves of H12 type N_2, H_2 compressor;
H12型氮氢压缩机低压气阀故障分析
2.
Research on service life of valves of the large reciprocating compressor;
大型往复式压缩机气阀寿命的探讨
3.
The operational reliability analysis of compressor s valve;
压缩机气阀工作可靠性分析
5) Gas-valve
气阀
1.
In this paper,gas-valve′s burnt-cost effect of diesel engine is analyzed in four aspects;The concrete method and measure to improve gas-valve s burnt-cost are summarized,which made diesel engine run in optimun state.
从四个方面分析了对柴油机气阀烧损的影响,总结了如何减少气阀烧损的具体方法和措施,从而使柴油机在最佳状态下运转。
6) air-valve
气阀
1.
Based on these faults and reasons of these destroyed air-valve,piston ring and cylinder overheat,some methods of improving valve shape,employing new material,and preprocess cooling water,delaying deposition,reducing air cylinder temperature and so on are given.
讨述了矿用L型活塞式压缩机常见故障及解决方法,针对气阀故障、活塞环损坏及气缸过热产生的原因和危害,提出了改进阀片形状,采用新材料加工阀片以及对冷却水进行预处理,降低其硬度,延缓结垢,从而降低气缸温度等有效的故障处理措施,延长了易损件的使用寿命,提高了空压机运行的安全性和经济性。
2.
This text has introduced the principle of computing air-valve s movement rule,set up the arithmetic model about the force on compressor s air-valve in the working process and induced the mathematic model of movement rule.
介绍了理论计算气阀运动规律的基本原理,建立了隔膜式压缩机气阀在工作过程中进气阀、排气阀所受的各个力的数学模型,得出气阀运动规律的数学模型。
补充资料：♀气阀钢748
gasvalvesteel：制造内燃机中的气阀用的钢。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条