说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 渐开线螺旋花键
1)  spiral involuting serration
渐开线螺旋花键
1.
This paper expounds the design,the manufacturing characteristics and the application of a new type of roolling wheel used for cold rolling the spiral involuting serration.
铣削加工的四键或六键矩形花键是汽车、拖拉机用起动机电枢轴上的传统结构 ,已逐渐被用冷滚轧加工的多键渐开线螺旋花键所代替。
2)  involute spline
渐开线花键
1.
Confirmation of the tolerance of involute spline measurements with pins;
渐开线花键跨棒距M极限偏差的确定
2.
Optimization of die parameters for involute spline part based on numerical simulation;
基于数值模拟的渐开线花键件凹模参数优化
3.
In accordance with space engaging principle and analyzing the processes of cold rolling involute spline,a general 3-D mathematic model of involute spline is built up.
通过对冷滚轧渐开线花键加工原理分析,按照空间啮合原理,建立了花键齿面三维数学模型,揭示了花键冷滚轧过程中滚轮和工件之间运动规律。
3)  involute splines
渐开线花键
1.
The paper first introduces a calculating method of the theoretical value on the base tangent length, number of spanned teeth (or spaces)and its tolerance for three kinds of the normal involute splines which respectively belong to China GB/T3478.
1和德国DIN5 480三种渐开线花键公法线长度的理论值、跨齿数(或跨齿槽数)及其上下偏差的计算方法,并对有关标准中相关数据查找的具体使用方法作了简明扼要的介绍。
4)  Involute teeth spline
渐开线齿外花键
5)  detection of involute spline
渐开线花键检测
6)  BRITISH Standard Involute splines
英制渐开线花键
1.
This paper introduces calculation and measurement of BRITISH Standard Involute splines.
介绍了平齿根齿侧配合英制渐开线花键计算、测量的基本公式及方法。
补充资料:渐开线
      平面上一动直线沿固定圆作纯滚动时,此直线上任意点的轨迹为该圆的渐开线(见图)。这一动直线BK称为发生线,固定圆O1称为基圆。K 的轨迹A1K为O1的渐开线。基圆越大,渐开线在相同压力角αK的某点K处的曲率半径也越大,如B2K大于B1K。当基圆趋于无穷大时,BK趋于无穷大,渐开线亦趋于直线AK。基圆内无渐开线。渐开线常用于齿轮轮齿的工作齿廓和花键工作齿廓。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条