1) eccentrically stiffened plate
偏心加筋板
1.
In this paper, the formulations and beam plate element model for large deformation analysis of eccentrically stiffened plates are presented.
给出了偏心加筋板大变形分析的理论公式和相应的梁板单元模型 。
2) stiffened swedged plate
加筋压筋板
3) tile lintel floor
空心砖加筋密接板
4) stiffened plate
加筋方板
1.
Method for scaling impact load data obtained from a small scale model to that of the full size clamped and stiffened plate;
固支加筋方板在均布冲击载荷作用下动态响应的相似畸变研究
5) stiffened plates
加筋板
1.
Large deformation dynamic plastic response of stiffened plates;
加筋板的大挠度塑性动力响应研究
2.
A study on deformation of blast-loaded stiffened plates;
爆炸冲击作用下加筋板结构变形研究
3.
Nonlinear dynamic response of stiffened plates under lateral impact loading;
横向冲击载荷下加筋板的非线性动力响应
6) strengthening tendon-plate
加强筋板
1.
By means of the analyzing for the reason resulting in the welding crack in a strengthening tendon-plate of a pressure vessel,the article puts forward the method that has resolved the problem having common phenomenon in pressure vessel operation and has been proved to be effective through practical application in years.
本文通过压力容器接管加强筋板焊缝裂纹产生原因的分析,提出了解决这一带有普遍现象问题的方法,并经实际运行证实了该方法的可行性。
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条