1) non sparking test
无火花试验
1.
This paper discusses a feasibility that,for increased safety brushless excitation synchronous motors, non sparking test is carried out by using the sudden short circuit method of generator when the motor runs inertially for replacing the no load full voltage starting.
讨论增安型无刷励磁同步电动机采用电机惰行时 ,发电机突然短路法代替电动机空载满压起动无火花试验的可行
2) non-sparking area test
无火花区域试验
3) spark test
火花试验
1.
The paper,by the theoretical analysis and calculation for the discharge time and the strike fire interval of IEC spart test device of the resistance-capacitance circuit,finds out the cause of the low sensitivity and approaches a new way to test ɑnd prove the capacitive circuit,in the prerequisite of no affect on the performances of the IEC spark test device.
目前 ,利用“IEC本安电路火花试验装置” ,对时间常数较大的电容性电路试验 ,在多数情况下都采用拔钨丝根数来实现。
2.
With regard to factory inspection, the article demonstrate test equipment, test voltage, functional check, Calibration and the way to handle non-conforming products of Spark test in CCC and VDE Product certification.
从火花试验设备、火花试验电压、火花机运行检查、火花机校准及火花不良样品的处理几个方面,并结合工厂检查实践,以CCC及VDE认证中对火花试验的要求作相应的阐述。
4) arc test
电火花试验
5) spark tester
火花试验器
6) sparkover test
飞火花试验
补充资料：电火花试验
分子式：
CAS号：
性质：运用火花放电原理，对胶接表面进行处理的试验方法。
CAS号：
性质：运用火花放电原理，对胶接表面进行处理的试验方法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条