1) few teeth difference internal gear meshing transmission
少齿差内啮合传动
3) internal gear transmission
齿轮内啮合传动
1.
Analysis on the restrictive condition of internal gear transmission;
渐开线齿轮内啮合传动的约束条件分析
4) outer mesh and "two teeth difference" planetary gear transmission
两齿差外啮合行星传动
1.
A new type of outer mesh and "two teeth difference" planetary gear transmission is studied in this dissertation.
基于两齿差外啮合行星传动的结构特点及使用工况分析,采用齿轮台架试验和数理统计方法,结合这种传动润滑和散热实验的研究结果,提出了其失效特征和机理,给出该传动的主要失效形式为“过度磨损”。
6) transimission with small tooth number difference
少齿差传动
1.
According to the characteristics of transimission with small tooth number difference,the geometry relation of normal profile back lash and gearing point was derived on the theory,and the mathematical model was set up for the optimal back lash spacing.
根据少齿差传动的特点,理论分析了啮合传动时齿侧法向间隙与啮合点位置的几何关系,建立了寻优求齿侧间隙的数学模型,并给出一个算例,为进一步对少齿差传动参数的选择和强度的分析奠定了基础。
2.
According to the characteristics of transimission with small tooth number difference,the geometry relation of normal profile back lash and gearing point were derived from the theory after meshing,and all the back lash values were worked out by optimal design.
根据少齿差传动的特点,理论分析了脱离啮合时齿侧法向间隙与啮合点位置的几何关系,建立了寻优求齿侧间隙的数学模型,为进一步全面对少齿差传动参数的选择和强度的分析奠定了基础。
补充资料：少内
1.汉大内属官﹐掌府藏。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条