1) standard double curved surface
准双曲面
1.
In this paper,the law of parameter B and 1/PQ influence contact spot is obtained in processing standard double curved surface gear of BJ130 with analyzing experiment.
通过实验分析得出参数B和1／PQ＇，在加工BJ130汽车后桥准双曲面齿轮时，对接触斑点的影响规律。
2.
In this paper, two control parameters, △Ax and △ x are influence of increased, the cuding gear test is made by processing standard double curved surface gear of BJ130.
本文提出增加两个控制参数△Ax与△x，并针对BJ130汽车后桥准双曲面齿轮做切齿试验，分析结果，找出参数△Ax和△x对接触斑点的影响规律。
2) hypoid gear
准双曲面齿轮
1.
Modeling and FEM Analysis of the Hypoid Gear Based on ANSYS;
基于ANSYS的准双曲面齿轮建模及有限元分析
2.
Tooth Surface Parameterization and Contacting Visualization of Hypoid Gear;
准双曲面齿轮齿面参数化和接触可视化方法研究
3.
Thus,using modified-roll method,4-axis CNC spiral bevel gear machine can manufacture hypoid gear.
这样,在四轴数控铣齿机上可以实现变性法加工准双曲面齿轮。
3) Hypoid gears
准双曲面齿轮
1.
Experimental investigation on running performance of hypoid gears;
准双曲面齿轮副台架性能试验
2.
Based on NC machining principle of hypoid gears, three-dimensional modeling method for CNC machine tool, workpiece and cutter is introduced.
根据准双曲面齿轮数控加工原理,提出了CNC铣齿机、齿轮毛坯和盘铣刀实体模型的具体构建方法;利用简化的齿轮毛坯实体模型和盘铣刀实体模型做布尔减运算,在计算机上实现了模拟工件材料的去除过程;通过加工仿真结果和实际加工结果对比,验证了加工仿真方法的正确性。
4) hypoid bevel gear
准双曲面锥齿轮
1.
This paper researches the design method of shrinkage tooth with equal tip clearance of hypoid bevel gear pair with half generating method, which will increase the contact ratio,engagement factor,load capacity and stability of the transmission.
研究了用半展成法加工的收缩齿等顶隙准双曲面锥齿轮副的设计方法,以求提高齿轮重迭系数、承载能力和传动平稳性。
5) hypoid pinion
准双曲面小齿轮
6) hypoid gear pair
准双曲面齿轮副
补充资料：双叶双曲面
双叶双曲面
two-sheet hyperboloid
r皿ep60”OH口l 见双曲面(11yperboloid)双叶双曲面〔two一叙eth押材加loid;皿。yno月ocTn曰丽
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条