说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 接触线载荷
1)  contact line pressure
接触线载荷
1.
A calculating model of the teeth contact line pressure of the worm gear driving in normal lubrication and wear condition is proposed.
建立了蜗杆副在常规的润滑与磨损传动条件下,齿面接触线载荷的计算模型。
2)  contact load
接触载荷
1.
In order to investigate the fractal behavior of friction signal and the change regularity of its fractal dimension with sliding velocity and contact load,friction and wear tests of pin(GCr15 steel)-on-disc(C45 steel) were carried out on an MMW-1 type wear tester.
在立式万能摩擦磨损试验机上对GCr15/45#钢摩擦副进行不同接触载荷和滑动速度下的摩擦磨损试验,对初始滑动距离1000 m内的摩擦系数信号进行数据采集,运用结构函数测度方法对摩擦系数信号进行分形表征,计算不同载荷和速度下的分形维数,研究摩擦信号的分形维数随载荷和速度的变化规律。
2.
The results show that the interfacial temperature is 240-560 ℃, the maximum contact load can reach 15.
研究结果表明:接触界面温度变化范围为240~560℃,接触载荷能够达到15。
3.
Nondimensional contact load has a larger influence on the conductive than the radiant conductivity,and for the non-contact area decreasing as the non-dimensional contact load increasing,the conductive conductivity increasing quickly and the radiant conductivity decreasing slowly.
数值计算表明:当接触表面的温度高于400K时,辐射的影响已不可忽略;载荷对接触导热热导的影响明显大于对辐射热导的影响,导热热导随载荷的增大迅速增大,而辐射热导以及等效辐射系数均随载荷的增大有所减小,这主要是由接触界面的空隙面积减少造成的;在接触面几何参数中,粗糙峰等效斜率对等效辐射系数起着主导作用,在相同的量纲1的载荷情况下,粗糙峰等效斜率越小,等效辐射系数越大;通过对本文提出的等效辐射系数的误差检验,结果表明其最大相对误差为10-3数量级,说明等效辐射系数仅仅为接触界面黑度、几何特性和接触载荷的函数,而与接触界面温度水平和温差无关,同时也间接证明了本文提出的等效辐射系数可以较为合理地描述接触界面间的辐射换热强度。
3)  load contact condition
载荷接触条件
4)  wheel/track contact load
轮轨接触荷载
5)  virtual contact loading method
虚拟接触载荷法
6)  impact contact load
冲击接触载荷
补充资料:混合式钢丝绳(见线接触钢丝绳)


混合式钢丝绳(见线接触钢丝绳)
alternate type steel wire rope

  hunheshl gangslsheng混合式钢丝绳(alternate type Steez wireroPe)见线接触钢丝绳、
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条