说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 铆合层梁
1)  Laminated riveted beam
铆合层梁
2)  laminated beam
层合梁
1.
Nonlinear dynamic response for composite laminated beam with delamination under considering the effect of contact
考虑接触效应的具脱层复合材料层合梁的非线性动力响应分析
2.
It is significant to study the numerical simulation method of the flexural failure process of laminated beams reinforced with woven fabric.
机织物层合梁弯曲破坏全过程的数值模拟分析对揭示其破坏规律,评价其耗能能力,预测其极限承载能力都十分有益,并有望在一定程度上代替大量的实验。
3.
In this paper,bending failure experiments have been carried out for five groups of laminated beams reinforced with unidirectional woven fabrics.
五组单向机织物增强层合梁的弯曲实验表明:层合梁的最大弯曲强度通常并不对应于最后一层破坏时的荷载;铺设角不同的层合梁达到最大承载力时,破坏并不发生在同一层,且总的破坏层数和对应位移都不相同,其破坏形式可以定性预测。
3)  composite beam
层合梁
1.
Analysis on contact damage problem of composite beam;
复合材料层合梁接触损伤问题的分析
2.
The nonlinear contact problem of composite beams is linearized by an inverse method, that is to say, the loading distribution on the contact zone with the adjustable parameter and the contact width are assumed to be given and the curvature of the cylinder is to be solved.
首先根据叠加原理将受力状态分解成对称和反对称状态 ,然后用正交完备的三角级数和勒让德级数构造这两种受力状态的位移场 ,并应用最小势能原理确定位移场中的待定系数 ,从而确定层合梁的位移场和应力场。
3.
The vibration of a composite beam, embedded with piezo-electric film, is analysed in the paper, Hamilton principle is made in use to analyse the coupled effect between piezo-elec-tricity and structure deformation,considering the influence of electric field on deformation, the e-quation of motion of a composite beam is derived.
本文分析由压电材料进行控制的复合层合梁,利用哈密顿原理分析压电效应与结构变形的耦合作用,考虑到电场条件对结构变形的影响,推导出压电层合梁的运动方程,并求得了压电层合梁固有特性与电场的关系。
4)  Timoshenko laminated composite beam
Timoshenko层合梁
5)  laminate beam
层合梁
1.
An analysis of tension and bend coupling effect for laminate beam;
层合梁拉伸和弯曲耦合效应分析
2.
A composite laminate beam element based on the higher-order shear deformation theory;
基于高阶理论的高精度层合梁单元
3.
For the delamination of composite laminate beam stacked orthogonally and symmetrically with four plies under transverse loading, the magnitudes of J1 -integral along different paths are obtained on the basis of the determination of the SIF and all of the coefficients in the expansions.
对于对称正交铺层复合材料层合梁的分层问题,在利用分区广义变分原理确定了应力强度因子K_Ⅱ以及应力与位移本征展开式中的所有待定系数的基础上,进一步求出守恒积分值。
6)  laminated boxbearn
层合箱梁
补充资料:N,N-二缩水甘油2,4,6-三溴苯胺玻璃布层合板
分子式:
CAS号:

性质:以三溴苯胺环氧树脂为基料的玻璃布层合板。耐燃性好,相对密度>1.98。机械强度除冲击强度(190kJ/m2)和剪切强度(119MPa)外,其他略次于E-51环氧树脂。将三溴苯胺环氧树脂与有关添加剂配成胶液后,手工糊于玻璃布上,叠层并层合固化即得。可用于要求耐燃的航空、船舶和机电行业。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条